Memories, Image Picture | Meridian Audio FDP-DLPHD20 instruction

MEMORIES

The main parameters of the image may be saved in distinct groups of values (known as ‘Memories’); these parameters can subsequently be applied all together by way of a single com- mand.

There are 3 distinct Memories (Memory 1, Memory 2, Memory

3) for each of the 8 signal types managed:

		1	VIDEO
		2	S-VIDEO
3	COMP/RGB(YCrCb 15KHz)			3 COMP/RGB(RGB 15KHz)
3	COMP/RGB(YCrCb)			3 COMP/RGB(RGB)
	4	GRAPHICS RGB
	5	DIGITAL INPUT

making a total of 24 different available Memories.

The image parameters that can be saved/recalled by the Memo- ries management system are the following:

Image	Picture
BRIGHTNESS	ASPECT
CONTRAST	COLOR TEMP. GAIN (R/G/B)
COLOR	COLOR TEMP. GAIN OFFSET (R/G/B)
TINT	COLOR TEMP.
SHARPNESS	OVERSCAN
FILTER	GAMMA
SHARPNESS MODE
VIDEO TYPE
NOISE REDUCTION

Some of these parameters may not be available for certain in- puts or certain input signals, as indicated in Tables 1 and 2. The menu page for the Memories management functions is

activated by pressing the key on the remote control or the

key on the keypad (Fig.36).

	4	H
ZOOM	4	GRAP
2		(R
1	CONTROL

Fig.36

The operations that can be performed on each memory se- lected are described here below.

SAVE A MEMORY

To save the current values of the image parameters in Memory 1, use the and keys to move to line ‘1’ and then open the pull-down menu by pressing the key (Fig.37). Then select the option ‘Save current settings’. To confirm that the operation has been completed successfully, the message ‘Current set- tings saved in Memory 1’ is displayed at the bottom of the screen and the letter ‘S’ appears to the left of the memory name. The same procedure is used to save parameters in Memories 2 and 3.

Memories
0	Auto
1	S	Save current settings
		Save current settings
2	I	Save initial settings
3	S	MEMORIARename 1
		Fig.37

RECALL A MEMORY

To recall a Memory, select the desired line and press . The parameters saved in the selected Memory will be applied to the image displayed and a message will appear to confirm the operation ‘Memory 1 recalled’. The Memory recalled will be associated with the source and signal type, and will be auto- matically recalled every time that particular source and signal type combination is selected.

SAVE DEFAULT SETTINGS

To restore the original values to a previously modified Memory, select the line corresponding to the Memory in question and open the pull-down menu ( key). Then select the line “Save default settings”. To confirm that the operation has been com- pleted successfully, the message ‘Initial settings saved in Memory 1’ is displayed at the bottom of the screen and the letter ‘I’ appears to the left of the name of the memory.

RENAME A MEMORY

It is possible to assign a name to each Memory. To assign a name (with a maximum length of 12 alphanumeric characters) to a Memory, select the option ‘Rename’ from the correspond- ing pull-down menu. Enter the text following the procedure in- dicated in paragraph “SOURCE LIST”.