Meridian Audio FDP-DLPHD20 installation manual 100-240 Vac

Please follow carefully the warnings listed below, to ensure safe and long term performance of your projector.

•Connect the projector to a power supply with a nominal voltage within the following values: 100-240 Vac, 50/60 Hz, earthed (Fig. 3).

							ne pas		compromettre
					pour			les resque		type
					contre			de meme
	ATTENTION:					un	fusible
	la	protection								against
				par
	remplacer				caracteristique
								protection
	et	de mems
				for continued
	CAUTION: replace
	risk of		fire,			type
				same
	only with			fuse.
	and rating							AUDIO
		5	DIGITAL
								OUT
3			INPUT

pas		compromettre
				d'incende
resque				type
e de			meme
tique				against
ed	protection

1

AUDIO

OUT

2

4

250 V

T 3.15A H

3

100-240 Vac

50/60 Hz

Fig. 3

•The mains plug is the disconnect device. Take care, when installing, that the mains plug and socket outlet are easily accessible. Never pull on the cable to take it out of the socket. If the system is unlikely to be used for a number of days, disconnect the power cable and other apparatus connected to it.

•To save energy, switch off the projector by using the power switch at the rear; when in stand-by (red light on) the projector continues to draw a minimal amount of power.

•Only replace the safety fuse (on the power socket at the rear of projector) with a fuse identical in type and characteristics (T 3.15A H) (Fig. 4).

•Do not switch on your projector when flammable liquids or fumes are present. Do not pour or drop fluids in the vents.

•Do not use the projector when the room temperature is above 35°C (95°F).

Fig. 4

•Do not obstruct the cooling air inlets on the top cover, or the air outlets underneath the projector.

•Do not switch on the projector if it is standing on soft surfaces such as cushions, pillows, blankets, mattresses and carpets: the air cooling outlets underneath could become obstructed.

•Do not switch-on the projector if it is standing on surfaces sensitive to heat, as this may result in damage caused by the hot air outlets underneath. Should this be unavoidable take extra precaution of protecting the surfaces with a layer of heat resistant material.

•Intense Light Source! Do not stare directly into the projection lens as possible eye damage could result. Be especially careful that children do not stare directly into the beam.

•Do not open the projector’s cover; no user serviceable parts are inside. Refer servicing to qualified service personnel. Opening the projector’s cover will invalidate warranty.

•Take care not to shake the projector whilst carrying it by the handle.

•Always position the projector away from direct heat sources.

5