A TECHNICAL SPECIFICATIONS
OPTICAL | ELECTRICAL |
Projection system: | optical engine based on 1 DMD™ |
| HD2+ chip, sealed housing, dusty proof |
DMD™ panel: | resolution 1280x720 pixel |
Brightness uniformity: | 10% above or below the average |
Contrast ratio: | > 2800:1 (full On / full Off) |
Projection lens: | zoom, 12 elements AR multilayer |
| coating, motorized focus and zoom, |
| manual elevation |
Aperture f#: | 2.7 (zoom max) - 3.3 (zoom min) |
Picture size: | |
Aspect ratio: | 4/3 and 16/9 |
Throw ratio: | 1.8:1 - 2.5:1 |
(throw distance: picture width) |
|
Focus range: | 2.2 - 13.0 m (7’ 3” - 42’ 8”) |
Throw Distance: | 60”: 2.4m - 3.3m (7’ 11” - 10’ 10”) |
| 80”: 3.2m - 4.4m (10’ 6” - 14’ 5”) |
| 100”: 4.0m - 5.5m (13’ 2” - 18’ 1”) |
Keystone adjustement: | up to 26° (optical: ± 8° digital: ±18°) |
Lamp: | 120 W |
Lamp life time: | 6000 hours (average value measured |
| in the laboratory under optimal condi- |
| tions; it can be sensibly reduced by |
| the unit misusing) |
Input Signals: | CVBS on RCA/Phono type connector |
| |
| RGBHV on DB15HD connector |
| RGBS / YCrCb on RCA/Phono type |
| connector |
| Digital Input |
Horizontal frequency: | from 15 to 80 kHz (up to to UXGA |
| format @ 60 Hz) |
Vertical frequency: | |
Video standards : | automatically selected (PAL B,G,H, I, |
| M,N,60, SECAM, NTSC 3.58, 4.43) |
High definition video: | ATSC HDTV (480p, 720p, 1080i) |
Graphic standards : | VGA, SVGA, XGA, SXGA, UXGA |
Deinterlacer: | Faroudja chip set, DCDi™, 3:2 pull |
| down sequence convertion |
Colour temperature: | adjustable from 5000 to 9300 degrees |
| K |
Video processor: | DTI, CTI, comb filter, noise reduction. |
| Sharpness, Y/C delay and NTSC tint |
| adjustments |
Remote control: | via infrared remote control and via |
| computer through RS232 serial |
| interface |
Low Voltage Power Output: two 12 Vdc output, 100 mA max on jack connectors
27