Marantz RX9001 manual Configuring the Extender, Configuration with a direct connection to the PC

Page 13

RX9001 User Guide

4Plug in the Extender’s power adapter.

The Extender will start up. After startup, the Power and Ethernet LEDs are green. The Busy LED blinks green when it’s processing a code or a macro.

Configuring the Extender

You can connect the Extender directly to the PC for configuration.

If the Extender is already installed and connected to external equipment, it is also possible to configure it through a router. For further instructions, refer to the topic ‘Configuration through a router’ on page 11.

Tip

To ensure optimal performance, use a dedicated network for all wireless

 

communication. This makes the Wireless

Network independent of other networks and

 

changes in network settings.

 

Configuration with a direct connection to the PC

1Connect the Extender to the PC with the configuration cable (this is the crossed Ethernet cable enclosed).

Crossed

Ethernet cable

Extender

2Make sure that the PC is switched to DHCP while the Extender is in configuration (normally, this should already be the case).

3Set the Configuration switch to 2 for configuration:

Configuration switch: 2

The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy LED is red/green blinking.

4Open the browser.

5Type the IP address of the Extender in the address bar of the browser: 192.168.8.80. (This is also printed on the back of the Extender.)

You may have to refresh the browser before the Configuration Tool appears.

6Make sure you have the IP address and netmask at hand, and follow the onscreen instructions.

7When the configuration is completed, disconnect the Extender from the computer and reconnect it to the router with a straight Ethernet cable. Set the Configuration switch to 1 for use.

ENGLISH

10

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model RX9001 User Guide Serial Extender Avertissements RX9001 UserRX9001 UserGuideGuide RX9001X9001 User GuideUser Guide ContentsBefore You Start Serial Extender Unpacking the ExtenderMounting the Extender in a Rack Installing the ExtenderAdjusting the Power Level of the IR Outputs Connecting the Extender to External EquipmentAttaching the Extender to Infrared Controlled A/V equipment Wizz.it Ex Using the Sensor InputsConnecting to Serial Equipment Connecting to Relay-controlled EquipmentOpen Wizz.it Ex Open the configuration file Connecting to a Lutron RadioRa Lighting SystemOpen the Lutron Lighting System Properties Using the Extender Connecting the Extender to the NetworkSet the Configuration switch to 1 for use Inserting a Multimedia Server in the NetworkConfiguration with a direct connection to the PC Configuring the ExtenderSet the Configuration switch to 2 for configuration Set the Configuration switch to 3 for configuration Configuration through a routerTools menu, select Extender Discovery Support TroubleshootingWhat Do the LEDs Indicate? There is an IP conflictResetting the Extender Firmware UpdateOperating A/V components with the Extender Updating the Extender through a Router Serial Extender User Guide SpecificationsRemarks RX9001 User Guide RX9001 User Guide Czech Likvidace starého výrobku FCC CompliancyDanish Bortskaffelse af dit gamle produkt Dutch Verwijdering van uw oude productFrench Mise au rebut des produits en fin de vie Finnish Vanhan tuotteen hävittäminenGerman Entsorgung Ihres alten Geräts Hungarian Az elhasznált termék hulladékkezeléseIii Marantz America, Inc Corporate Drive Mahwah, NJ07430 Is a registered trademark
Top Page Image Contents