Onkyo DV-SP1000E Before Use, Installing the Remote’s Batteries, Using the Remote Controller

Before Use

Setting the Voltage Selector (Worldwide model only)

The Worldwide model has a voltage selector for compat- ibility with power systems around the world. Before you plug in this model, make sure that the voltage selector is set to the correct voltage for your area. If it isn’t, use a small screwdriver to set it as appropriate. For example, if the voltage in your area is 120 volts, set the selector to “120V.” If it’s between 220 and 230 volts, set it to “220- 230V.”

RS 232	HDMI	VIDEO OUT	AUDIO OUT	IR	D. MIX	FRONT	SURR 1	CENTER	SURR 2
		COMPONENT

Y	DIGITAL 1	DIGITAL 2		IN	L		L	SUPER AUDIO CD & DVD AUDIO/
								VIDEO PLAYER
								MODEL NO. DV-SP1000
P					R		R
				REMOTE			SUB
	COAXIAL OPTICAL	COAXIAL	OPTICAL	CONTROL		AUDIO OUT	WOOFER
P
VIDEO IN
						HD VIDEO OUT		AC INLET
S400						COMPONENT
( AUDIO)					Y	P	P	VOLTAGE SELECTOR
S VIDEO

			220-230V	120V
			12V
			TRIGGER
	VIDEO	S VIDEO	VIDEO
1	1+ 2		IN

SURR MODE

(AUDIO OUT)

VOLTAGE SELECTOR

220-230V 120V

Installing the Remote’s Batteries

1 To open the battery compartment, press the small hollow and slide off the cover.

2 Insert the three supplied batteries (AA/R6) in accordance with the polarity markings inside the battery compartment.

3 Put the cover onto the remote controller and slide it shut.

Notes:

•The supplied batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replacing both batteries.

•Don’t mix new and old batteries, or different types of batteries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion.

•Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion.

Using the Remote Controller

To use the remote controller, point it at the DV-SP1000/ DV-SP1000E’s remote control sensor, as shown below.

Remote control sensor

DV-SP1000/

DV-SP1000E

				.
30˚		.16		ft
30˚
	x		m)
	Appro	(5

Notes:

•The remote controller may not work reliably if the DV-SP1000/DV-SP1000E is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the DV-SP1000/DV-SP1000E.

•If another remote controller of the same type is used in the same room, or the DV-SP1000/DV-SP1000E is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvert- ently, thereby draining the batteries.

•The remote controller may not work reliably if the DV-SP1000/DV-SP1000E is installed in a rack behind colored glass doors. Keep this in mind when installing the DV-SP1000/DV-SP1000E.

•The remote controller will not work if there’s an obsta- cle between it and the DV-SP1000/DV-SP1000E’s remote control sensor.

14