InFocus SP8602, SP8600 manual When the power cord or plug is damaged or frayed

Page 5
•When the power cord or plug is damaged or frayed

8’ / 2

.4

m

 

 

 

3’/1m

 

 

m

 

 

.5

 

1

/

 

 

 

5

 

 

2’ /0.

 

6

m

 

Unplug this projector from the wall outlet and refer servicing to qualified service personnel under the following conditions:

When the power cord or plug is damaged or frayed

If liquid has been spilled into the projector

If the projector has been exposed to rain or water

If the projector does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as improper adjustment of other controls may result in damage and may required extensive work to restore the projector to normal operation

If the projector has been dropped

When the projector exhibits a distinct change in performance, this indicates a need for service.

Follow these instructions to help ensure image quality and lamp life over the life of the projector. Failure to follow these instructions may affect the warranty. For complete details of the warranty, see the Warranty Booklet.

4

Image 5
Contents Page Trademarks Declaration of ConformityFCC Warning CanadaTable of Contents Important Operating Considerations for Safety When the power cord or plug is damaged or frayed Product specifications Optional AccessoriesIntroduction Online registration12V External Trigger outputs Connector panelHorizontal Offset +/-15% Positioning the projectorRange of distance to the screen for a given screen size Ceiling MountCable management Connecting a computer source Connecting powerHDMI 1.3 connection VGA connectionNo start up screen? Get help on page Displaying an imageAdjusting the image Video device connections Connecting a video deviceComposite video connection S-video connectionWhat is Aspect Ratio? Table 1 Status indicator light behavior and meaning Troubleshooting your setupShutting down the projector Screen Save TimeSolution Problem No start up screen Only start up screen appearsPlug power cord into the projector, then press power buttonNo computer image, just the words “Signal out of Problemrange” Only my laptop’s background appears, not theresolution of the projector Start Settings Control Set your computer’s display resolution to the nativePanel Display Settings tab Move projector, adjust zoom and lens shiftAdjust Sharpness in the Basic Picture menu Adjust Keystone in the Basic Picture menuImage not square Square imageTurn off Rear Project in Setup menu Turn off Ceiling Mount in Setup menuAdjust color, tint, brightness, contrast in the Basic Image upside downTurn off the internal LCD display on your laptop The video embedded in my PowerPointEmbedded video plays correctly presentation does not play on the screenLamp must be replaced see page “Replace lamp” message appears at startup, lampwon’t turn on, Lamp light is turned on Replace lamp Lamp doorTroubleshooting the remote Using the remote controlOptimizing computer images Using the keypad buttonsPresentation features Customizing the projector Optimizing video imagesUsing the menus Basic Picture menu Advanced Picture menu Setup menu Menu Transparency Allows you to change how much of the projected image Help Status and Service menuWARNINGS MaintenanceCleaning the lens unplug projector Replacing the projection lampTurn off and Using the security lock HDMI AppendixSplitScreen Compatibility Communication Configuration RS-232 CommandsRS-232 Port Settings Command FormatLimitations Write Command ExamplesError Conditions Resolution 1 TimerSignal Blank Screen Style1 Lamp won’t strike Lamp Total On Time 1 Display Projector Info menu1 Reset Reset Lamp HoursSave User Presets CommandSystem State Numerics INDEX