Onkyo HT-S5200 instruction manual Error Messages, To Retry the Room Correction and Speaker Setup

Page 41

First Time Setup—Continued

5

When the following display appears,

 

 

move the speaker setup microphone to

 

measurement point c (page 39), and

 

then press [ENTER].

 

 

 

 

 

 

Audyssey 2EQ™ performs more measurements.

This takes a few minutes.

When the measurements are complete, the results are calculated and saved automatically.

6

When the room correction and speaker

 

 

setup is complete, disconnect the

 

speaker setup microphone.

 

 

 

 

 

 

 

 

 

 

 

 

Note:

When the room correction and speaker setup is complete, “6. Equalizer” (page 72) will be set to “Audyssey.”

Error Messages

While the room correction and speaker setup is in progress, one of the following error messages may appear:

❏Ambient noise is too high

This message appears if there’s too much background noise and the measurements cannot be performed properly. Remove the source of the noise and try again.

❏Speaker Detect Errors

This message appears if one of the speaker-related errors below occurs.

•One of the front speakers has not been detected.

•One of the surround speakers has not been detected.

❏Write Error

This message appears if saving fails.

❏Mismatch Error

This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again.

To Retry the Room Correction and Speaker Setup

Press the [ENTER] button.

Make sure speakers that cannot be detected are connected properly.

Changing the Speaker Settings Manually

If you wish to make changes to the settings found during the room correction and speaker setup, follow the directions on pages 70–72.

Using a Powered Subwoofer

If you’re using a powered subwoofer, as it outputs very low-frequency sound and its position is usually low down, it may not be detected by the Audyssey 2EQ Room Correction and Speaker Setup. In this case, increase the subwoofer’s volume, select its highest crossover frequency, and then try running the Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, it may not be detected, so use an appropriate volume level.

41

Page 40 Page 42
Image 41
Page 40 Page 42
Contents HT-S5200 Avis Important Safety InstructionsPower PrecautionsPreventing Hearing Loss Caution Batteries and Heat Exposure WarningPackage Contents Speaker PrecautionsPackage Contents Speaker Sets a and B Using Two Sets of SpeakersAmplifier FeaturesProcessing ConnectionsFeatures Contents Front Panel Front & Rear PanelsDisplay Front & Rear PanelsRear Panel VCR/DVR IN/OUT CBL/SATDVD/BD Subwoofer PRE OUTSubwoofer SKW-570 Speaker PackageSpeaker terminals Speaker PackageKeyhole slots Controlling the AV receiver Remote ControllerAiming the Remote Controller Remote ControllerInstalling the Batteries Enjoying Home Theater Connecting the AV receiverSpeaker Connection Precautions Connecting the AV receiverSpeaker Configuration Connecting Speaker Set B Connecting Speaker Set aWall Mounting Using the Rubber Stoppers for a More Stable PlatformUsing the Floor Pads for Subwoofer Connecting the Indoor FM Antenna Connecting AntennaConnecting the AM Loop Antenna Attach the FM antenna, as shownUsing a TV/FM Antenna Splitter Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna AV Cables and Jacks About AV ConnectionsOptical Digital Jacks AV Connection Color Coding Which Connections Should I Use? Connecting Audio and Video Signals to the AV receiverVideo Connection Formats Audio Connection FormatsAbout Hdmi Connecting Components with HdmiAbout Copyright Protection Pass-ThruTip Making Hdmi ConnectionsVideo Connection Connecting a TV or ProjectorAudio Connection HintConnecting a DVD/BD player Connecting a VCR or DVR for Playback Make the audio connection a Connecting a VCR or DVR for RecordingSatellite, cable, set-top box, etc Make the video connection a Make the audio connection a Connecting a Camcorder, Game Console, or Other DeviceConnecting a Portable Audio player CD Player or Turntable MM with Built-in Phono Preamp Step Connecting a CD Player or TurntableConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Connecting the Supplied UP-A1L Dock Connecting an RI DockNot all iPod models output video If Your iPod Supports VideoConnecting the Power Cord Connecting Onkyo u ComponentsAuto Power On/Standby Direct ChangeTurning On and Standby Turning On the AV receiverUp and Running in a Few Easy Steps Did you connect an Onkyo MD recorder or CD recorder?Measurement Positions First Time SetupAudyssey 2EQ Room Correction and Speaker Setup Using Audyssey 2EQ First Time SetupTo Retry the Room Correction and Speaker Setup Error MessagesChanging the Speaker Settings Manually Using a Powered SubwooferDigital Input Setup Component Video Input SetupFollowed by the Setup button Press the Setup buttonChanging the Input Display Basic Operations Select a listening mode and enjoyBasic AV receiver Operation Start playback on the source componentUsing the Sleep Timer Setting the Display BrightnessBasic Operations Muting the AV receiverAdjusting the Bass & Treble 7Using Headphones Displaying Source InformationSpecifying the Digital Signal Format Using the Music OptimizerButtons to select 8.Hardware AM/FM Frequency Step SetupListening to the Radio Listening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio Displaying AM/FM Radio Information Selecting Presets Presetting AM/FM StationsDeleting Presets Listening to Sirius Satellite Radio Setting Up the SiriusConnect Home TunerListening to Sattellite Radio Positioning the AntennaListening to Sirius Satellite Radio Setting the Satellite Radio ModeSelecting Sirius Satellite Radio Signing Up for Sirius Satellite RadioSelecting Sirius Satellite Radio Channels Channel Search ModeDirect Tuning Category Search ModePresetting Sirius Channels Displaying Sirius Satellite Radio Information Deleting PresetsPositioning the SiriusConnect Home Tuner See the previous sectionParental Lock Changing the PIN Number About the UP-A1L Dock UP-A1L Dock for iPodCompatible iPod models Putting Your iPod in the DockControlling iPod UP-A1L Dock for iPodStatus messages Recording the Input Source RecordingRecording from Different AV Sources Selecting with the Remote Controller Using the Listening ModesSelecting the Listening Modes Selecting on the AV receiverMono/Multiplex Sources Using the Listening ModesListening Modes Available for Each Source Format Stereo Source DTS-ES Discrete/Matrix Sources Channel SourcesAbout the Listening Modes Onkyo Original DSP Modes Speaker Settings Advanced SetupCommon Procedures in Setup Menu Crossover Crossover Frequency Advanced SetupDouble Bass Sp Distance Speaker DistanceLeft and Right e/ r buttons to adjust the level at that Equalizer Equalizer SettingsLevel Cal Speaker Levels Calibration Use the Down w button to select Ch, and then use the LeftPLIIx/Neo6 Music Mode Settings PLIIx Music 2ch Input Audio Adjust SettingsAudio Adjust Multiplex/Mono Settings Theater-Dimensional Setting Dolby EX Input Signal SettingAudyssey Settings Hardware Setup Using the Audio Settings Music Optimizer Audyssey Dynamic VolumeSpeaker Levels SyncControlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Remote Control Codes for Onkyo Components Connected via u Resetting the Remote ControllerResetting the Remote Mode Buttons Controlling Other ComponentsControlling a DVD Player, or DVD Recorder Controlling a CD Player, CD Recorder, or MD Player Previous and Next 7/6 buttons Controlling a Cassette RecorderRewind and Fast Forward 5/4 buttons Reverse Play t buttonControlling an RI Dock When Using an RI DockTroubleshooting Troubleshooting Sound changes when I connect my headphones AV receiver’s remote controller doesn’t control your iPodCan’t control other components There’s no soundVideo Attenuation Video ATT0 defaultAmplifier Section SpecificationsVideo Section Tuner SectionSubwoofer SKW-570 SpecificationsFront Speaker SKF-570 Center Speaker SKC-570Memo Memo 3 4 4 9 3

HT-S5200 specifications

The Onkyo HT-S5200 is a remarkable home theater system that offers an impressive blend of features, technology, and sound quality, making it an excellent choice for both audio enthusiasts and casual movie watchers alike. This 5.1 channel surround sound system is designed to provide an immersive audio experience, perfect for enhancing your favorite films, music, and video games.

At the heart of the HT-S5200 is the powerful 3D surround sound processing, which utilizes Dolby TrueHD and DTS-HD Master Audio formats. These technologies ensure that you experience high-definition audio that is crystal clear and richly detailed. Whether you're engrossed in an action-packed blockbuster or a heartfelt drama, the system delivers sound that transports you right into the action.

One standout feature of the HT-S5200 is its advanced 6.1-channel input, allowing for Dolby Digital and DTS surround sound processing. This enables the system to decode a wide range of audio formats, providing versatility for various media sources. The system is also equipped with multiple HDMI inputs, making it easy to connect all your favorite devices, from Blu-ray players to gaming consoles, ensuring a clutter-free setup.

The system comes with a well-designed 5.1 speaker configuration, which includes a subwoofer that delivers deep bass, enhancing your listening experience. The compact design of the satellite speakers makes them easy to integrate into any room, while still producing powerful sound that fills the space.

Another impressive aspect of the Onkyo HT-S5200 is its user-friendly interface, which includes an easy-to-navigate remote control and an intuitive on-screen display. This makes it simple to adjust settings and choose different audio modes, ensuring you get the most out of your home theater experience.

The HT-S5200 also features a variety of connectivity options, including Bluetooth, which allows for seamless streaming of music from your smartphone or tablet. This feature adds modern convenience to the system, enabling users to enjoy their favorite playlists without the hassle of cables.

In conclusion, the Onkyo HT-S5200 home theater system stands out as a powerful and versatile choice for anyone looking to elevate their home entertainment setup. With its advanced audio technologies, user-friendly design, and impressive sound performance, it promises to deliver a captivating surround sound experience that is sure to impress.
Top Page Image Contents