Onkyo HT-S5200 Advanced Setup, Common Procedures in Setup Menu, Speaker Settings

Advanced Setup

Common Procedures in Setup Menu

Remote indicator

RECEIVER

qwer

ENTER

SETUP

Number

Buttons

1	Press the [RECEIVER] button followed by
	the [SETUP] button.
2	Use the Up and Down [q]/[w] buttons to
	select the function, and then press the
	[ENTER] button.
3	Use the Up and Down [q]/[w] button to
	select item, and then use the Left and
	Right [e]/[r] buttons to set them.
4	When you’ve finished, press the [SETUP]
	button.

Setup closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

Speaker Settings

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a speaker after performing the Audyssey 2EQ™ Room Correction and Speaker Setup.

Some of the speaker settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 39).

3. Sp Config (Speaker Configuration)
These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker
Setup function (see page 39).
This section explains how to specify which speakers are connected and their sizes.
For speakers with a cone diameter larger than 6-1/2 inches (16 cm), specify Large (full
band). For those with a smaller diameter, specify Small (default crossover 150Hz).				Cone diameter
The crossover frequency can be changed on page 71.
Note:
These settings cannot be changed while a pair of headphones is connected, or speaker set A
is off, or speaker set B is on, or the AV receiver is muted.
	Subwoofer		Yes: Select if a subwoofer is connected (default).
			No: Select if no subwoofer is connected.
	Front*1		Small: Select if the front speakers are small (default).
			Large: Select if the front speakers are large.
	Center*2		Small: Select if the center speaker is small (default).
			Large: Select if the center speaker is large.
			None: Select if no center speaker is connected.
	Surround*2		Small: Select if the surround speakers are small (default).
			Large: Select if the surround speakers are large.
			None: Select if no surround speakers are connected.
*1		If the “Subwoofer” setting is set to “No”, this setting is fixed at “Large” and does not appear.
*2		If the “Front” setting is set to “Small”, the “Large” option cannot be selected.

70