Onkyo HT-S5200 instruction manual Controlling Other Components, Preprogrammed Remote Control Codes

Controlling Other Components

You can control your DVD player, CD player, and other components with the AV receiver’s remote controller. To control another component, you must first enter that component’s remote control code to a REMOTE MODE button.

This section explains how to enter remote control codes and how to control your other components.

1	Look up the appropriate remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category
	(e.g., DVD player, TV, etc.).

Preprogrammed Remote Control Codes

The following REMOTE MODE buttons are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components. For details on controlling these components, see the pages indicated.

Onkyo DVD/BD player (page 80) Onkyo CD player (page 81)

Onkyo cassette recorder with u(page 82) Onkyo Dock (pages 61, 83)

Entering Remote Control Codes

You’ll need to enter a code for each component that you want to control.

Remote	DISPLAY
indicator

2

(3 seconds)

While holding down the REMOTE MODE button to which you want to enter a code, press and hold down the [DISPLAY] button until the Remote indicator lights up (about 3 seconds).

Note:

•Remote control codes cannot be entered for the [RECEIVER] button.

•Only TV remote control codes can be entered for the [TV] button.

•Apart from the [RECEIVER], [TV] buttons, remote control codes from any category can be entered for the REMOTE MODE buttons. However, these buttons also work as input selector buttons (page 44), so choose a REMOTE MODE button that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose the [CD] button when entering its remote control code.

REMOTE	RECEIVER
MODE
AUDIO

Number buttons

3	Within 30 seconds, use the
	number buttons to enter the 5-
	digit remote control code.
	The Remote indicator flashes twice.
	If the remote control code is not entered
	successfully, the Remote indicator will
	flash once slowly.

Note:

The remote control codes provided are correct at the time of printing but subject to change.

78