Onkyo CR-B8 Programming a Timer, Repeatedly press Timer to select the desired timer number

CRB8.book 47 ページ ２００５年８月１８日 木曜日 午後６時４０分

Using the Timer Functions—Continued

Programming a Timer

Before programming a timer for an AM/FM broadcast, program the desired broadcast stations to the preset channels. (See pages 34 and 36.)

Notes:

•You cannot use the timer functions unless the clock is set.

•If you do not operate the buttons for 60 seconds during the timer setting, the unit returns to its normal display.

•The following procedures are performed on the unit. When you use the remote controller to perform these procedures,

press / instead of turning MULTI JOG and press ENTER instead of MULTI JOG.

Display
	9	1
9	Number buttons
	1-8	1-8
1	1-8

1 CD receiver	Remote
	controller

Repeatedly press TIMER to select the desired timer number.

Select from Timer 1 to 4, then press MULTI JOG.

If only “Clock” is displayed, the day of the week and time have not been set. Set the day of the week and time.

2 CD receiver	Remote
	controller

Turn MULTI JOG to selectTimer Play or Timer Rec.

When the desired timer operation is dis- played, press MULTI JOG. The Timer Rec operation is performed on a connected CD recorder or tape deck. During recording, the muting function is activated.

or

3 CD receiver	Remote
	controller

Turn MULTI JOG to select the source.

When the desired source is displayed, press

MULTI JOG.

For the Timer Rec operation, you can select from FM, AM, HDD, TAPE, LINE, or CD.

FM or AM is selected

Turn MULTI JOG to select the preset num- ber.

When the desired preset number is displayed, press MULTI JOG.

47