Onkyo CR-715DAB First Time Setup, Setting the Clock with the AccuClock Function

First Time Setup

Setting the Clock with the AccuClock Function

To use the AccuClock function, the CD receiver must be able to receive RDS radio stations, which means an FM antenna must be connected. Be sure to connect an FM antenna before attempting to use this function (see page 14).

The very first time you turn on the CD receiver, the AccuClock function automatically sets the CD receiver’s clock based on the CT (Clock Time) information present in an RDS radio broadcast. While the clock is being set, “Wait…” flashes on the display, as shown. Note that it may take up to 5 minutes to set the clock.

When the clock has been set, the message “Clock Adjusted” scrolls across the display, then the day and time are dis- played for a while, as shown.

The AccuClock function automatically updates the clock daily at 2 A.M., 3 A.M., and 2 P.M.

If for some reason the clock cannot be set automatically, see “Setting AccuClock to Use a Specific Station” on page 47 and “Setting the Clock Manually” on page 48.

Turning Off the AccuClock Function

If you don’t want AccuClock to automatically update the clock each day, you can turn it off as follows.

TIMER YES/MODE

ENTER

1	Press the [TIMER] button repeat-
	edly until “Clock” appears on the
	display.

2	Press [ENTER].
	“*AccuClock*” appears on the display.
	The asterisks indicate that the
	AccuClock function is on.
3	To turn off AccuClock, press the
	[YES/MODE] button.
	The asterisks disappear, indicating that
	the AccuClock function is off. To turn
	AccuClock back on again, press the
	[YES/MODE] button so that the aster-
	isks are displayed.

Note:

The AccuClock function cannot be turned off until the clock has been set.

24