Onkyo CR-715DAB instruction manual Troubleshooting, Tuner, Remote Controller, External Components

Page 55

Troubleshooting—Continued

Can’t add tracks to the playlist for memory playback.

•Make sure there’s a disc in the CD receiver. Also, you can only add valid track numbers. For example, if the CD contains 11 tracks, you cannot add track #12.

The disc will not play.

•Make sure the disc has been loaded correctly, with the label-side facing up.

•Check to see if the surface of the disc is dirty (see page 13).

•If condensation is suspected, turn on the CD receiver and leave it for 1 hour before playing any discs.

•Some CD-R/RW discs may not be playable (see page 12).

It takes a long time for playback to start.

• It may take the CD receiver a while to read CDs that contain many tracks or files.

Tuner

Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn’t preset all stations, or the ST indicator doesn’t light up when tuned to a stereo FM station.

•Check the antenna connections (see page 14).

•Change the position of the antenna (see page 36).

•Move the CD receiver away from a nearby TV or computer.

•Cars or airplanes can cause noisy interference.

•The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.

•Try setting FM mode to mono (see page 36).

•Move power cords and speaker cables as far away as possible from the tuner’s antenna.

•If none of the above improves the reception, install an outdoor antenna (see page 15).

If a power outage occurs or the power cable is disconnected:

•If the preset stations are lost, preset them again (see pages 41, 42).

•The clock and timer settings will be lost. Set the clock and timers again (see pages 47, 48).

Can’t adjust the frequency of the radio.

• Use the tuning [ TUN]/[TUN ] buttons to change the frequency of the radio (see page 36).

RDS doesn’t work.

•The FM station you are tuned to doesn’t support RDS.

•Install an outdoor FM antenna (see page 15).

•Change the position or direction of your outdoor FM antenna (see pages 15, 36).

•Move the FM antenna as far away as possible from fluorescent lights (see page 36).

Remote Controller

The remote controller doesn’t work properly.

•Make sure the batteries have been installed with the correct polarity (+/–) (see page 5).

•Replace both batteries with new ones. (Do not mix different types of batteries or new and old batteries.)

•The remote controller is too far away from the CD receiver, or there’s an obstacle between them (see page 5).

•The CD receiver’s remote control sensor is being subjected to bright light (inverter-type fluorescent light or sunlight).

•The CD receiver is located behind the glass doors of a audio rack or cabinet.

External Components

Interactive control with other Onkyo -capable components is not working.

•Make sure the cables and analog audio cables are connected correctly (see pages 18 to 22). Connecting only an

cable won’t work.

•Make sure the Input Display matches the type of device that you’ve connected to the CD receiver (see page 27).

•When recording an MP3 CD to an Onkyo recording component, recording will start without performing a peak search when the [CD DUBBING] button is pressed on the recording component. This is not a malfunction.

55

Page 54 Page 56
Image 55
Page 54 Page 56
Contents CR-715 CR-715DAB Avis Important Safety InstructionsPower PrecautionsInstalling this Unit CD Player FeaturesPrecautions AmplifierBefore Using the CD Receiver Supplied AccessoriesInstalling the Batteries Contents Front Panel Getting to Know the CD ReceiverDisplay Getting to Know the CD ReceiverRear Panel Remote Controller Using the Remote Controller Supported Discs Disc NotesMP3 Disc NotesConnecting the DAB Antenna CR-715DAB only Connecting AntennasConnecting the Indoor FM Antenna Connecting an Outdoor FM Antenna Connecting AntennasUsing a TV/FM Antenna Splitter Connecting Your Speakers Connecting SpeakersCables and Jacks Connecting Other ComponentsConnecting a Subwoofer About ConnectionsConnecting an Onkyo Cassette Deck Connecting Other ComponentsWhat can you do with Connecting an Onkyo MD recorderCD receiver’s Rear panel Connecting an Onkyo CD RecorderWhat can you do with ? Connecting an Onkyo Component with a Digital Audio OutputHint Connecting a TVConnecting a Portable Audio Device Connecting the Power CordPlug the power cord into a suitable wall outlet Setting the Clock with the AccuClock Function First Time SetupTurning Off the AccuClock Function Turning On the CD Receiver Adjusting the VolumeUsing Headphones Basic OperationBasic Operation Adjusting the Bass and TrebleUsing the Super Bass Function Using the Direct FunctionInput Source Name Abbreviations Changing the Input DisplaySelecting Tracks Playing CDsDisplaying CD Information Playing CDsSelecting MP3 Files in Navigation Mode Selecting MP3 Files in All Folder Mode Playing the MP3 Files in Only One Folder Memory Playback Press the YES/MODE/SHUFFLE DOM indicator appearsRandom Playback Repeat PlaybackPreferences Use the Tuning TUN/TUN buttons to tune into a station Tuning into FM Radio StationsAdjusting the Antennas Tuning into weak stereo FM stationsReceiving RDS What is RDS?Listening to the Radio Displaying Radio InformationPress the Band button repeat- edly to select DAB Using the Auto Tuning Function ManuallyListening to DAB Digital Radio CR-715DAB only Selecting DAB for the Very First TimeSelecting DAB Stations Use the Tuning TUN/TUN buttons to select the DAB sta- tionsDisplaying DAB Radio Information DAB Setup After Storing Presets You Can Presetting FM Stations Automatically Auto PresetTune into the station that you want Presetting FM/DAB Stations ManuallyAbout Presets To store as a presetListened to the radio will still be selected Selecting Preset StationsUse the Band or Input Buttons to select FM, or DABAvailable Characters Naming PresetsCopying Presets Erasing Presets Erasing a Preset’s NameSetting AccuClock to Use a Specific Station Setting the ClockDisplaying the Time in Standby Mode Setting the ClockSetting the Clock Manually Using the 12- or 24-hour FormatAbout the Timers Using the TimersIf Clock appears, you need to set Using the TimersProgramming the Timers You must set the clock before you can programPress the STANDBY/ON button If you selected Once, use the PreIf you selected Every, use the Pre If you selected Days Set, usePress Enter repeatedly to see Turning Timers On and OffChecking Timer Settings All of the timer’s settingsCanceling the Sleep Timer Using the Sleep TimerChecking the Remaining Sleep Time CD Playback TroubleshootingPower AudioExternal Components TroubleshootingRemote Controller TunerTimers Tuner Section SpecificationsGeneral Amplifier SectionMemo Memo 3 4 4 3 3
Top Page Image Contents