Onkyo CR-715DAB instruction manual Setting the Clock, Setting AccuClock to Use a Specific Station

Setting the Clock

Setting AccuClock to Use a Specific Station

The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock cannot be set properly using that station, you can specify which FM station the AccuClock function should use. This must be an FM station that supports RDS CT (Clock Time) information.

1

2

3

4

Press the [TIMER] button.			5	When you’ve selected the station,
				press [ENTER].
“Clock” appears on the display.
				While the clock is being set, “Wait”
If the clock has already been set, a timer
				flashes on the display. It may take a few
option appears instead, in which case
				minutes to set the clock. When the clock
you’ll need to press the [TIMER] button
				has been set, the message “Clock
repeatedly until “Clock” appears.
				Adjusted” scrolls across the display, then
Press [ENTER].				the day and time are displayed for a
“AccuClock”or “*AccuClock*” appears				while.
				Notes:
on the display.
If “Manual Adjust” appears, use the Pre-				• If the clock is not set correctly, specify
vious and Next [	]/[	] buttons to		another FM station and try again or set
select “AccuClock” or “*AccuClock*”.				the clock manually (see page 48).
				• The AccuClock function automati-
Press [ENTER].				cally updates the clock every day. If
The frequency flashes on the display.				you don’t want it to, you can turn off
				the AccuClock function (see page 24).

Use the Rewind and Fast Forward []/[ ] buttons to tune into the FM station.

Tip:

If you press the [YES/MODE] button instead of using the Rewind and Fast Forward []/[ ] buttons, the CD receiver will automatically search for a suitable station.

The RDS indicator appears when tuned into a station that supports RDS.

The RDS indicator will flash while the CD receiver searches for a station and light up continuously when a station is found.

RDS indicator

47