Replacing the projection lamp
The lamp hour timer in the Service Info menu counts the number of hours the lamp has been in use. Twenty hours before the specified end of the lamp’s life, the message “Change lamp” briefly appears on the projected screen.
NOTE: You can order new lamp housings from www.infocus.com (in select areas), your retailer or your dealer. Use only a replacement lamp with the same type and rating as the original lamp.
The part number is
1Turn off the projector and unplug the power cable.
2Wait 45 minutes to allow the projector to cool thoroughly.
3Loosen the lamp cover screw on the right side of the projector (marked by the arrow) then slide and lift the lamp cover off.
WARNINGS:
•To avoid burns, allow the projector to cool for at least 45 minutes before you replace the lamp.
•Do not drop the lamp module. The glass may shatter and cause injury. Do not touch the glass lamp screen. Fingerprints can obscure projection sharpness.
•Be extremely careful when removing the lamp housing. In the unlikely event that the bulb ruptures, small glass fragments may be generated. The lamp housing is designed to contain these fragments, but use cau- tion when removing the lamp housing. Before replacing the lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement. This product has a lamp which contains a very small amount of mercury. Dispose of it as required by local, state or fed- eral ordinances and regulations. For more information see www.eiae.org.
Service Info menu
turn off and unplug the projector
wait 45 minutes
lamp cover screw
34