Connecting to Video Equipment
(such as a Laser Disc player, a DVD player, a DSS,or a Video Camera)
●Read SAFTEY GUIDELINES ( 
to 
) carefully to ensure maximum safety before proceeding to these steps:
1)Choose an appropriate site and install the product on a level table where the stand is secure.
■Install the monitor to have ready access to a power socket available.
2)Make sure that the video equipment’s power switch is off.
3)Interconnect the signal input terminal on the monitor rear panel and the video equipment’s signal output terminal to each other using an optional cable.
4)Insert one end of the power cable included into the
5)Turn on the monitor, then the video equipment’s to make sure that a display image appears on the monitor screen.
■For instructions on turning on the monitor and adjusting its display images, see “Operating Instructions” ( 9 to 17 ).
Monitor rear panel
Video equipment
(such as a Laser Disc player,
a DVD player, a DSS,or a Video Camera)
ENGLISH
SPEAKER TERMINAL
Power |
|
| |
cable | output terminals | To Svideo | |
Power cable | |||
|
|
connector
AUDIO IN
VIDEO2VIDEO1
(8‰8W)
WhiteL/MONO
(W)
R 
Nearer Terminal
White
(W)
Further terminal
COMPONENT IN
COMPOSITE IN
+ - - +
R L
Red (R)
terminalsTo audio input
Red
(R)
terminals | video input | To audio/ |
PR/CR PB/CB | Y | VIDEO | S | terminals | ToSvideo |
|
| Yellow |
|
|
|
|
| (V) |
|
|
|
|
|
|
|
| input |
To component |
|
|
| ||
| input terminals |
|
|
| |
Use if the video equipment has an
S video input terminal
■If video equipment with an S video output terminal is used, cabling by the S video cable is recommended to provide finer video quality. (If an S video input terminal and a video input terminal connect to the monitor at the same time, S video input would govern.)
7