Marantz PD4298HD s Reset Settings Initialization, Signal Check, Display menu item Application

INITIALIZE ?

YES NO

Reset (Settings Initialization)

●The shown to the right will be displayed when the

CURSOR/CONTROL button is used to select DISPLAY and

moreover DISPLAY INT is selected from the On-screen

Display System 12 . If the button (select YES) of the

CURSOR/CONTROL button is pressed at this time, the user adjustment values in the table below for the signal currently being received will be deleted and the factory settings will be restored.

■Pressing the button (select NO) cancels deletion and returns the DISPLAY menu.

DISPLAY menu item	Display	Application
H.POSITION	H.POSITION	RGB1, RGB2
V.POSITION	V.POSITION	RGB1, RGB2, VIDEO1, VIDEO2
CLOCK	CLOCK	RGB1, RGB2
PHASE	PHASE	RGB1, RGB2
Scan system	SCAN	RGB1, RGB2
Vertical size	V. SIZE	VIDEO1, VIDEO2
Display area	DISPLAY AREA	RGB1, RGB2
Display size	DISPLAY SIZE	VIDEO1, VIDEO2

Signal Check

●The status of signal reception is checked automatically and the result is displayed on the screen.

ENGLISH

Status	Display	Action
Signals are received	• The input terminal and the	-
normally.	horizontal and vertical
	frequencies are displayed in
	a guidance image.
A sync signal could	• The guidance message	• Check the power
not be detected.	“POWER SAVE” is displayed	switch of the PC
	for about 5 seconds.	and its status of
	• In the event of continued	connection.
	absence of a sync signal, the
	power indicating lamp flickers
	and the monitor enters power
	save mode.
The input signal	• The guidance message	• Check the input
does not meet	“OUT OF FREQUENCY” is	signal
display	displayed for about 5	specifications
specifications or	seconds.	once again.
erratic.		26 , 28

￿RGB1 [D-SUB]

￿H : 46.5kHz, V : 60Hz

Either VIDEO or S VIDEO is displayed on VIDEO input.

POWER SAVE

￿OUT OF FREQUENCY ￿

19