Onkyo CR-525, CR-325 instruction manual Changing the Input Display, Input Source Name Abbreviations

Basic Operations—Continued

Changing the Input Display

You can choose what name is displayed when an input source is selected so that it matches the type of component that you’ve connected to the MD/TAPE IN. When you connect an Onkyo u-capable component, it’s important that you select the input source name that matches the type of component for uto work properly.

INPUT

/

MENU/NO

/

ENTER

1	Use the INPUT [t]/[1] buttons
	to select “TAPE”.

2	Press and hold the [MENU/NO]
	button until “Name Select?”
	appears on the display, and then
	press [ENTER].
	HOLD

3	Use the Previous or Next
	[7]/[6] button to select the
	new input source name.
	The input source names are selected in
	the following orders:
	TAPE	MD	VIDEO*

DAT*

*When you select an input source name, you cannot select it as the recording component at the set timer recording.

4	Press [ENTER] to confirm your
	selection.
	“Complete” appears on the display.

Input Source Name Abbreviations

Sometimes the input source name may be displayed as a 2-letter abbreviation, as per the following table.

Full name	Abbreviation
DAT	DT
MD	MD
TAPE	TP
VIDEO	VD

27