Onkyo CR-325, CR-525 instruction manual Using the Timers, Programming the Timers

Using the Timers—Continued

Programming the Timers

Notes:	3
• You must set the clock before you can program the

timers.

• Before programming a timer to turn on the radio, you must preset the station you want to use. (See pages 42 and 43.)

• If you don’t operate any buttons for 60 seconds while programming a timer, the procedure will be cancelled and the previous display will reappear.

STANDBY/ON
Number buttons
/	TIMER	4
	ENTER

1 Press the [TIMER] button repeat-

edly to select timer 1, 2, 3, or 4, and then press [ENTER].

5

If “Clock” appears, you need to set the clock (see pages 24, 49, and 50).

2	Use the Previous and Next [7]/
	[6] buttons to select “Play” or	6
	“Rec”, and then press [ENTER].

or

If you can’t select “Rec”, make sure that your Onkyo cassette deck or MD recorder is properly connected to the MD/TAPE jacks (see pages 21 and 22) and the Input Display is set accordingly (see page 27).

Use the Previous and Next [7]/ [6] buttons to select the source, and then press [ENTER].

You can select the following sources:

CR-525

FM, AM, TAPE, USB, DOCK, or CD.

CR-325

FM, AM, TAPE, DOCK, or CD. If you selected “Rec”, only “FM” or “AM” can be selected as the source.

If you selected “AM” or “FM”, use the Previous and Next [7]/[6] buttons to select the radio preset, and then press [ENTER].

If you selected “Rec”, make sure the name of the connected recorder is flashing on the display, and then press [ENTER].

Use the Previous and Next [7]/ [6] buttons to select “Once” or “Every”, and then press [ENTER].

Select “Once” for on-off operation. Select “Every” to perform the same oper- ation every week.

52