Onkyo CR-525, CR-325 instruction manual Precautions, Power, Installing this Unit

Page 3

Precautions

1.Recording Copyright—Unless it’s for personal use only, recording copyrighted material is illegal with- out the permission of the copyright holder.

2.AC Fuse—The AC fuse inside the unit is not user- serviceable. If you cannot turn on the unit, contact your Onkyo dealer.

3.Care—Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild deter- gent and water. Dry the unit immediately afterwards with a clean cloth. Don’t use abrasive cloths, thin- ners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel let- tering.

4.Power

WARNING

BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SEC- TION CAREFULLY.

AC outlet voltages vary from country to country. Make sure that the voltage in your area meets the voltage requirements printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC 120 V, 60 Hz).

The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable (easily accessible) at all times.

Pressing the [STANDBY/ON] button to select Standby mode does not fully shutdown the unit. If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet.

5.Never Touch this Unit with Wet Hands—Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer.

6.Handling Notes

•If you need to transport this unit, use the original packaging to pack it how it was when you origi- nally bought it.

•Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the case.

•This unit’s top and rear panels may get warm after prolonged use. This is normal.

•If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure to use it occasionally.

•When you’ve finished using this unit, remove all discs and turn off the power.

7.Installing this Unit

•Install this unit in a well-ventilated location.

•Ensure that there’s adequate ventilation all around this unit, especially if it’s installed in an audio rack. If the ventilation is inadequate, the unit may overheat, leading to malfunction.

•Do not expose this unit to direct sunlight or heat sources, because its internal temperature may rise, shortening the life of the optical pickup.

•Avoid damp and dusty places, and places subject to vibrations from loudspeakers. Never put the unit on top of, or directly above a loudspeaker.

•Install this unit horizontally. Never use it on its side or on a sloping surface, because it may cause a malfunction.

•If you install this unit near a TV, radio, or VCR, the picture and sound quality may be affected. If this occurs, move this unit away from the TV, radio, or VCR.

8.To Obtain a Clear Picture—This unit is a high- tech, precision device. If the lens on the optical pickup, or the disc drive mechanism becomes dirty or worn, the picture quality may be affected. To maintain the best picture quality, we recommend regular inspection and maintenance (cleaning or worn part replacement) every 1,000 hours of use depending on the operating environment. Contact your Onkyo dealer for details.

9.Moisture Condensation

Moisture condensation may damage this unit.

Read the following carefully:

Moisture may condense on the lens of the optical pickup, one of the most important parts inside this unit.

•Moisture condensation can occur in the following situations:

–The unit is moved from a cold place to a warm place.

–A heater is turned on, or cold air from an air conditioner is hitting the unit.

–In the summer, when this unit is moved from an air conditioned room to a hot and humid place.

–The unit is used in a humid place.

•Do not use this unit when there’s the possibility of moisture condensation occurring. Doing so may damage your discs and certain parts inside

this unit.

If condensation does occur, remove all discs and leave this unit turned on for two to three hours. By this time, the unit will have warmed up and any con- densation will have evaporated.

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents CR-525 CR-325 Avis Important Safety InstructionsPrecautions PowerInstalling this Unit Brown Live PrecautionsCD Player FeaturesSupplied Accessories AmplifierBefore Using the CD receiver Installing the BatteriesUsing the Remote Controller Contents Getting to Know the CD receiver Front PanelCR-525 CR-325 Getting to Know the CD receiver Display Rear Panel RC-721S CR-525 RC-660S CR-325 Remote ControllerSTANDBY/ON button 25, 50 Timer button 24, 49, 50, 52Previous/Next 7/6 PRESET/PRESET r buttons 29 Volume q/w buttons 25Example Shows the case of h YES/MODE/SHUFFLE button Controlling an Onkyo MD recorder, cassette deck, or RI DockDiscs Made on Personal Computers Disc NotesSupported Discs CD-R/RW CompatibilityHandling Discs Disc Content OrganizationCleaning Discs Disc NotesAttach the FM antenna, as shown North American Model Connecting AntennasConnecting the Indoor FM Antenna Connecting the AM Loop AntennaUsing a TV/FM Antenna Splitter Connecting AntennasConnecting an Outdoor FM Antenna Connecting an Outdoor AM AntennaConnecting Speakers Connecting Your SpeakersTerminal posts Connection Color Coding Connecting Other ComponentsConnecting a Subwoofer About ConnectionsConnecting Other Components Connecting an Onkyo Cassette DeckWhat can you do with u? Connecting an Onkyo MD recorder For European models Connecting the Power CordConnecting an Onkyo RI Dock Remote Interactive Dock Plug the power cord into a suitable wall outletFirst Time Setup European models only Setting the Clock with the AccuClock FunctionTurning Off the AccuClock Function Turning On the CD receiver Adjusting the VolumeUsing Headphones Basic OperationsBasic Operations Adjusting the Bass and TrebleUsing the Super Bass Function Using the Direct FunctionInput Source Name Abbreviations Changing the Input DisplaySelecting Tracks Playing CDsTotal Remain Playing CDsDisplaying CD Information RemainTo start playback, press the Enter or Play 1 button Selecting MP3 Files in Navigation ModeSelecting/Playing MP3 Files While playback is stopped, press the Folder buttonSelecting MP3 Files in All Folder Mode Playing the MP3 Files in Only One Folder Displaying MP3 InformationMemory Playback Repeat Playback Random PlaybackPreferences Setting MP3 PreferencesFolder Key? USB Mass Storage Device Folders and Files Using USB interface CR-525 onlySupported Audio File Formats USB Mass Storage Device RequirementsSelecting Music files in other folders Using USB interface CR-525onlyPlaying Music Files on a USB Mass Storage Device Selecting Music filesSelect the type of Repeat Playback Cancelling Resume PlaybackResume Playback Random PlaybackDisplaying Music File Information Tuning into Radio Stations Adjusting the AntennasListening to the Radio Presetting FM Stations Automatically Auto Preset After Storing Presets You CanListening to the Radio About Presets Presetting AM/FM Stations ManuallySelecting Preset Stations What is RDS? Displaying Radio InformationReceiving RDS European models only Available Characters Naming PresetsCopying Presets To erase the preset, press Enter Erasing a Preset’s Name Erasing PresetsButtons to tune into Setting the ClockPress the Timer button When you’ve selected the station Use the Rewind and Fast ForwardDisplaying the Time in Standby Mode Setting the ClockSetting the Clock Manually Using the 12- or 24-hour FormatAbout the Timers Using the TimersYou must set the clock before you can program Using the TimersProgramming the Timers Edly to select timer 1, 2, 3, or 4, and then press EnterButtons to specify the On Timer indicator 1, 2, 3, or 4 willIf you selected Once, use If you selected Every, useThen press Enter Turning Timers On and OffChecking Timer Settings All of the timer’s settingsUsing the Sleep Timer Canceling the Sleep TimerChecking the Remaining Sleep Time Troubleshooting Troubleshooting Can’t play WMA files Timers Timer playback or recording doesn’t workClock Time is not displayed in Standby mode Can’t play MP3 filesTuner Section SpecificationsGeneral Amplifier Section3 4 4 7 0
Top Page Image Contents