Grundig CP-731i user manual Installing the Batteries, Attaching the Projector Handle

Page 6

BEFORE USE (continued)

Installing the Batteries

Install the AA batteries into the remote control

transmitter.
1.	Remove the battery cover.
	Push the knob while lifting up the battery cover.
2.	Load the batteries.
	Make sure the plus and minus poles are correctly	1	2
	oriented.	1	2
3.	Close the battery cover.

CAUTION

•Use only the specified batteries with this remote control transmitter. Also, do not mix new and old batteries. This could cause battery cracking or leakage, which could result in fire or personal injury.

• When loading the batteries, make sure the plus and minus terminals are correctly oriented as indicated in the remote control transmitter. Incorrect orientation could cause battery cracking or leakage, which could result in personal injury or pollution of the surrounding environment.

•When you dispose of the battery, follow the law in your area or country.

•Keep the battery away from children and pets.

•When not using the remote for an extended period, remove the batteries from the remote control transmitter.

NOTE: Replace the batteries when remote control transmitter operation becomes difficult.

ENGLISH

Attaching the Projector Handle

Attaching the enclosed handle needed.

1.Raise up the handle hook, and pass one end of the handle through the hole of handle hook.

2.Buckle the end of the handle, per diagram at right.

3.Fix the other end of the handle to the other handle hook in the same way.

1

2

CAUTION

Make sure the handle is firmly attached before carrying the projector with the handle. If the projector is dropped , it could result in an injury, and continued use could result in fire or electrical shock.

ENGLISH-5

Image 6

Contents CP-731i Contents Features Contents of packageBefore USE Before USE Part NamesDisk PAD Installing the Batteries Attaching the Projector HandleAngle Adjustment InstallationInstallation of the Projector and Screen Installation ReferenceInstallation CablingPlug & Play Power ConnectionExample of system setup Video tape recorder With S jackSwitching Power OFF Switching the Power Supply ON/OFFSwitching Power on OperationsOperations Basic OperationBasic Operation Description Normal menu Setup Menu Setup MenuInput Menu Select video signal typeInput Menu RGBImage Menu AdjustmentImage Menu Operation start/stop Press the or buttonOptions Menu Setup initial timer valueOptions Menu Operation start/stop PressStart UP No Signal MenuNo Signal Menu Clear initial screen display Select Turn OFF withLamp MaintenanceLamp Lamp LifeMaintenance Resetting the Lamp TimerReplacing the Lamp Maintenance Inside the Equipment Air Filter MaintenanceOther Maintenance Cleaning the LensOSD Message TroubleshootingMessage Contents OSD MessagesIndicators Message TroubleshootingIndicators Message IndicatorSymptom SymptomSymptom Possible cause Remedy Specifications SpecificationsWarranty Limited WarrantyCP-731i Video Signal Pin Assignment Dimension DiagramRGB Signal Pin Assignment TechnicalExample of computer signal Resolution FH kHz FV Hz Rating Signal mode DisplayInitial set signals TechnicalUSB Mouse Connection to the Mouse ControlPS/2, ADB or Serial Mouse PS/2 MouseADB Mouse Serial MouseRS-232C communication Communications settingCommand data ProtocolUsing the projector default settings Reset Command Requesting projector status Get commandChanging the projector settings Set command Increasing the projector setting value Increment commandCRC Example of Return OFF Be EF Be EF Ntsc PAL Regulatory Notices FCC Statement WarningFor the Customers in Canada Warranty