Grundig CP-731i user manual Regulatory Notices, FCC Statement Warning, For the Customers in Canada

Page 38

REGULATORY NOTICES

FCC Statement Warning

WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult BOXLIGHT or an experienced radio/TV technician for help. INSTRUCTIONS TO USERS: This equipment complies with the requirements of FCC (Federal Communication Commission) equipment provided that the following conditions are met:

The cables (Power cord, RGB cable and other cables) may have to be used with the core set to the projector side. Use the cables which are included with the projector or specified in this manual.

Core

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For the Customers in CANADA

NOTICE: This Class B digital apparatus complies with Canadian ICES-003.

REGULATORY NOTICES - 1

Page 37 Page 39
Image 38
Page 37 Page 39
Contents CP-731i Contents Before USE FeaturesContents of package Before USE Part NamesDisk PAD Installing the Batteries Attaching the Projector HandleAngle Adjustment InstallationInstallation of the Projector and Screen Installation ReferenceInstallation CablingPlug & Play Power ConnectionExample of system setup Video tape recorder With S jackSwitching Power OFF Switching the Power Supply ON/OFFSwitching Power on OperationsBasic Operation Description OperationsBasic Operation Normal menu Setup Menu Setup MenuInput Menu Select video signal typeInput Menu RGBImage Menu AdjustmentImage Menu Operation start/stop Press the or buttonOptions Menu Setup initial timer valueOptions Menu Operation start/stop PressStart UP No Signal MenuNo Signal Menu Clear initial screen display Select Turn OFF withLamp MaintenanceLamp Lamp LifeReplacing the Lamp MaintenanceResetting the Lamp Timer Maintenance Inside the Equipment Air Filter MaintenanceOther Maintenance Cleaning the LensOSD Message TroubleshootingMessage Contents OSD MessagesIndicators Message TroubleshootingIndicators Message IndicatorSymptom Possible cause Remedy SymptomSymptom Specifications SpecificationsWarranty Limited WarrantyCP-731i Video Signal Pin Assignment Dimension DiagramRGB Signal Pin Assignment TechnicalExample of computer signal Resolution FH kHz FV Hz Rating Signal mode DisplayInitial set signals TechnicalUSB Mouse Connection to the Mouse ControlPS/2, ADB or Serial Mouse PS/2 MouseADB Mouse Serial MouseRS-232C communication Communications settingCommand data ProtocolUsing the projector default settings Reset Command Requesting projector status Get commandChanging the projector settings Set command Increasing the projector setting value Increment commandCRC Example of Return OFF Be EF Be EF Ntsc PAL For the Customers in Canada Regulatory NoticesFCC Statement Warning Warranty
Top Page Image Contents