Marantz VP-15S1 manual Wait at the least one hour for the lamp

3. Wait at the least one hour for the lamp and

lamp unit to cool down.

5.Remove the lamp cover screw.

8. Holding the handle and pull the lamp unit out	11. Install the lamp cover back in its original
toward your side.	position and fasten with the fastening screw.

ENGLISH

4. Read the caution and warning labels on the

unit.

Lamp cover

A

WARNING

ATTENTION :ATTENTION CHAUD :

AB

For USA

WARNING

THIS COVER IS PROVIDED WITH

INTERLOCK TO REDUCE THE RISK OF

EXCESSIVE ULTRAVIOLET RADIATION.

DO NOT DEFEAT ITS PORPOSE OR

ATTEMPT TO SERVICE WITHOUT

REMOVING COVER COMPLETELY.

For Europe

CAUTION HOT

UNPLUG THE POWER CORD AND

WAIT 60 MINUTES BEFORE

CHANGING THE LAMP.

ATTENTION CHAUD

DEBRANCER LE CORD ON

D'ALIMENTION ET ATENDER 60

MINUTES AVANT DE CHANGER

LAMPE.

WARNUNG HEISS

ZIEHEN SIE DEN NETZSTECKER

AB UND WARTEN SIE 60 MINUTEN,

BEVOR SIE DIE GLUHLAMPE

WECHSELN.

B

For USA

CAUTION : HIGH PRESSURE LAMP	CAUTION HOT : UNPLUG	M
MAY EXPLODED IF IMPROPERLY HANDLED.	THE POWER CORD AND WAIT
REFER SERVICING TO QUALIFIED SERVICE	60 MINUTES BEFORE CHARGING
PERSONNEL.	THE LAMP.
ATTENTION : LA LAMPE SOUS	ATTENTION CHAUD :
HAUTE PRESSION PEUT SI ELLE, N'EST	DEBRANCER LE CORD ON
PAS MANIPULEE CORRECTEMENT,	D'ALOMENTION ET ATENDER
CONFIER L'OPERATION A UN	60 MINUTES AVANT DE
PERSONNEL D'ENTRETIEN QUALIFIE.	CHANGER LAMPE.

For Europe

CAUTION	VORSICHT :
HIGH PRESSURE LAMP MAY EXPLODED IF	BEI FALSCHER HANDHABUNG M
IMPROPERLY HANDLED. REFER SERVICING	KANN DIE HOCHDRUCKLAMPE
TO QUALIFIED SERVICE PERSONNEL.	EXPLODIEREN UBERLASSEN
ATTENTION	SIE WARTUNGSARBEITEN
	NUR FACHPERSONAL.
LA LAMPE SOUS HAUTE PRESSION PEUT
EXPLOSER SI ELLE, N'EST PAS MANIPULEE
CORRECTEMENT, CONFIER L'OPERATION
A UN PERSONNEL D'ENTRETIEN QUALIFIE.

6.Remove the lamp cover in the direction of the arrow.

Lamp cover

7.Open the cover sheet and remove the two screws (slotted head screwdriver required) that lock down the lamp unit. Do not remove any other screws.

Cover sheet

Lamp unit

9.Install a new lamp unit in position securely.

10.Lock the lamp unit in place with the two screws removed in step 7. Press on the handle until it folds over and close the cover sheet.

(a)

(b)

12.Plug in the video projector and turn on the power and project the image.

•If the lamp is replaced before reaching its

2000 hours lamp life, see “Reset Lamp Life” (☞ P.30).

•If the lamp is replaced after reaching its

2000 hours lamp life, see “Initialize the Lamp Life” (☞ P.31).

32