Controls and Features
Front Side/ Top Surface/ Left Side
1Control Panel
2 AC Power Input
Terminal
3 Carrying Handle
5 Lens |
4 Foot Lever |
(for front adjustable foot)
Using the Carrying Handle
pZoom Ring
9 Focus Ring
8 Remote Sensor (Front)
7 Air Inlet
4 Foot Lever
(for front adjustable foot)
6 Lens Cap
1Control Panel
For details, See ‘Control Panel on the Projector’. (☞ page 10, 11)
2AC Power Input Terminal
This is where the supplied power cord is connected to. (☞ page 24)
3Carrying Handle
Use this handle when carrying the projector.
4Foot Lever (for front adjustable foot)
Use when extending and retracting the front foot. (☞ page 15)
7Air Inlets (on the front, right, and bottom side of projector)
The air inlets absorb air to cool the internal components of the projector. Do not block or allow warm air to blow into them as it may cause damage.
•The air inlet filter on the right side cannot be removed. Please clean the filter regularly with, for example, a vacuum cleaner.
8Remote Sensor (Front)
When operating with the remote control, aim it towards this sensor. (☞ page 18)
•A remote sensor is also provided at the rear of the pro- jector.
5Lens
The lens is a 1.3 x (zoom ratio) manual zoom lens. Before projection, remove the lens cap. (☞ page 17, 24)
9Focus Ring
Used to manually focus the projected image on the screen. (☞ page 26)
6Lens Cap
It is recommended that the cap be fitted on the lens to pre- vent it from becoming dirty when the projector is not in use. (☞ page 24)
pZoom Ring
Used to manually zoom the projected image on the screen. (☞ page 26)
7