How to Use SET-UP MENU (cont.)
7Functions and Adjustment Range of Items
FUNCTION SETTING
Sets the control systems for the COLOR SYSTEM, colors of the tally lamp, and MAKE/TRIGGER terminal.
• Can be also used to check the amount of time that the monitor has been used.
7COLOR SYSTEM Selects the color system.
AUTO: Changes NTSC and PAL automatically.
NTSC: Keeps the color system NTSC.
PAL: Keeps the color system PAL.
NOTE:
•Normally select “AUTO.” However, if the input signal is unstable, select “NTSC” or “PAL.”
7HOUR METER X100h
Displays the total usage time of the monitor in
• 000 O 655
NOTES:
•When the timer passes 655, it returns to 000.
•The timer does not count usage time under one hour.
PICTURE SUB ADJ.
The standard value (“00”) of the picture adjustment is initially set at the factory. You can adjust the standard value as you want.
7TALLY SELECT
Selects the color of the tally lamp on the upper right of the front panel.
GREEN: The tally lamp lights in green.
RED: The tally lamp lights in red.
NOTES:
•“TALLY SELECT” does not appear on the menu when both of the following conditions are applied:
–When selecting “TA. SEL” to a pin terminal of the MAKE/TRIGGER terminal in “REMOTE SYSTEM” of
SET-UP MENU.
–When the external control is activated.
•The tally lamp is controlled using the MAKE/TRIGGER terminal of the REMOTE (external control) terminals.
☞“REMOTE SYSTEM” below, “How to Use the External Control” on pages 14 and 15
7REMOTE SYSTEM
Sets the MAKE/TRIGGER terminal.
☞“How to Use the MAKE/TRIGGER Terminal” on pages 14 and 15
•CONTROL FORM:
Selects the control system for the MAKE/ TRIGGER terminal.
MAKE: Selects the make contact system as
the external control method. TRIG.: Selects the trigger system as the
external control method.
SET: You can apply the functions to the 1st to 6th pin terminals of the MAKE/ TRIGGER terminal as you want.
•PORT F1 – PORT F6:
Selects the function to be applied to the 1st to 6th pin terminals of the MAKE/TRIGGER terminal.
☞ “How to Use the MAKE/TRIGGER Terminal” on page 14
NOTE:
•You can set “PORT F1” – “PORT F6” only when “CONTROL FORM” is set to “SET.”
7CONTRAST
•–20 O 00 O +20
7BRIGHT
•
7CHROMA
•
7PHASE
•
COLOR TEMP./BAL.
Sets or adjusts the color temperature and white balance.
NOTE:
•Use the five items indicated with 
mark to make fine adjustments between the monitors.
7COLOR TEMP.
Selects the color temperature.
HIGH: Sets the color temperature to 9300.
LOW: Sets the color temperature to 6500.
7BLUE DRIVE
Adjusts the blue drive level.
•MIN O 000 O MAX (in 127 grades)
7RED DRIVE
Adjusts the red drive level.
•MIN O 000 O MAX (in 127 grades)
7GREEN CUTOFF
Adjusts the green
•MIN O MAX (in 155 grades)
12