Using the LAN system, To join the network

Using the LAN system

Recommended	Operating system:	Microsoft® Windows® XP/Windows® Vista
operating environment	Browser:	Microsoft® Internet Explorer® 6.0 and 7.0
Cable	Ethernet cable (Category 5 or higher)

To join the network

<Main Control>

Basic controls of the monitor (such as turning on/off the power). You can also confirm the status of the monitor.

			Click to finish the operation.
Menu 1	Menu 2	Menu 3	Menu 4
Main Control	Motion Sensor Setting	General-Purpose Control	LAN Setting
			Log Out

For the operation procedure, see page 12.

NOTE

•About the IP address, sub net mask, default gateway, and DNS server, consult the person in charge of your network.

•Before starting the setting, connect the monitor to the network, turn on the monitor, then wait for about 30 seconds.

•Two or more PCs cannot log in at the same time.

•The PC automatically logs out in about 30 minutes after the last operation.

•LAN component of this monitor conforms to 10BASE-T.

1.Select “NETWORK SETTING” on the set-up menu.

2.Set “IP ADDRESS,” “SUBNET MASK,” “DEFAULT GATEWAY,” and “DNS SERVER.” 1 Press 5∞ to select the item, then press 3.

2 Enter the number by using 5∞ or number buttons. 3 Press 3 to move to the next item.

4 Press MENU to finish the setting.

Main Control & Status

1	Power
	On	Off

2Input Select

	VIDEO	RGB DVI
Volume Control
3	< >	10
MUTE	On	Off

	4	No Sync. Action
	4	OFF
		OFF

5	Dual Display Mode
	OFF PIP	PBP

ID No:	1
ID Address:	xx. xx. xx.xx
Status Information
Power Status:			ON

Selected Input:			VIDEO

Signal Status:			SIGNAL IN

Signal Format:			NTSC

Self Error Check:		OK
POWER UNIT:				OK

TEMP. SENSOR:				OK

PANEL:				OK
FAN:
				OK
OTHERS:
				OK
Error Code:				0

Get Status

• To restore the default setting, perform “reset” in “NETWORK SETTING.”

Operation on the web browser

Make sure that the monitor, personal computer, and router (or hub) is connected with the network cable, then turn on them.

Enable JavaScript of the browser before starting the operation.

1.Start Internet Explorer (6.0 or 7.0) on the computer.

2.Enter the IP address of the monitor to the address bar, then press Enter on the keyboard. The log-in screen appears.

GM-F420/470/520 Series

Web Control

Enter Log In Name :

1Turns on/off the monitor.

2 Selects the input.

3 Adjusts the volume level and activates/deactivates muting.

4 Selects the screen status while no signal is coming in.

5 Selects the Dual Display mode.

6 Displays the ID and IP address of the monitor.

7Displays the status of the monitor.

•Power to the monitor (turned on or off)

•Current input

•Status of the input signal (coming in or not)

•Input signal format

8Displays the self-check result of the monitor.

The status of the power unit, temperature sensor, monitor panel, etc. is indicated.

9Click to update the status display (6, 7, 8).

3.Click “OK.”

•No log-in name is set when shipped from the factory. See page 25 to set a log-in name.

4.Click the function tab you want to use.

•For details about each function tab, see the right and pages 24 and 25.

To finish the operation, click “Log Out.”