JVC LCT2505-001A-H manual LAN Setting

<LAN Setting>

Setting the log-in name for the control screen and E-mail of the monitor. You can also confirm the network setting.

Click to finish the operation.

Menu 1 Main Control

LAN Setting

Menu 2

Motion Sensor Setting

Menu 3	Menu 4
General-Purpose Control	LAN Setting

Log Out

3

1

2

MAC Address:	00:04:A3:00:00:05
IP Address:	10.52.41.39
Subnet Mask:	255.255.255.0
Default Gateway:	10.52.41.254
DNS Server:	192.168.0.1

Enter Log In Name:

ReEnter to Confirm:

OK

Set EMail Address

EMail Address to Send

SMTP Server

Mail Account

Mail Password

OK	Get Status	All Clear
Error Notification Mail		Send Test-Mail

1Displays the current network setting.

2Sets the log-in name to log in the web control screen.

• Up to 8 characters can be used.

Click “OK” to confirm the log-in name setting.

3E-mail settings for the monitor to send the error notification via E-mail.

• For details about the setting, consult the person

in charge of the mail server.

1Enter the mail address for the monitor.

2Enter the E-mail address (up to 3 addresses) to receive the error notification from the monitor.

• Up to 48 characters can be used for each

mail address.

3Enter the SMTP server address (up to 32 characters).

4Enter the E-mail account of the monitor (up to 16 characters).

5Enter the Email password of the monitor (up to 16 characters)

Click “OK” to confirm the mail setting.

Click “Get Status” to load the current settings. Click “All Clear” and then “OK” to delete the mail setting.

45

4Check here to receive the error notification from the monitor.

The error message is sent to the mail address specified in 3-2.

5Click to send the test mail.

•You may not be able to send E-mails depending on the network environment or the verification settings of the server.

•“POP before SMTP” is not supported.

25