JVC GM-V42S, GM-V42PCE manual Video a terminals COMPONENT/RGB B input terminals, Video B terminals

Note:

* GM-V42PCE, GM-V42PCEG and GM-V42PCEB do not have the following input terminals— VIDEO A, VIDEO B, and COMPONENT/RGB B. To input video, S-video, and component signals, you need to install video input unit (IF-C42P1G), which is separately purchased.

9 p q

AUDIO	VIDEO	AUDIO	VIDEO		AUDIO			VIDEO
L/MONO		L/MONO			L/MONO
R IN	OUT	R	IN	Y/C IN	R	Y/G	Pb/B	Pr/R HD/Cs VD
VIDEO A			VIDEO B			COMPONENT/RGB B

ENGLISH

9 VIDEO A terminals (page 12)	q COMPONENT/RGB B input terminals (page 12)
• AUDIO (L/MONO, R) input terminals (pin jack)	• AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio input terminals of a	Connect these terminals to the audio output terminals of
VCR, etc.	the other equipment.
• VIDEO IN terminal (BNC)	• G, B, R, HD/Cs, VD (VIDEO) input terminals (BNC)
Connect this terminal to the video output terminal of a	Connect these terminals to the following output
VCR, etc.	terminals of a personal computer or other equipment:
• VIDEO OUT terminal (BNC)	– Analog RGB signal output terminals
Connect this terminal to the video input terminal of	– Horizontal sync (HD) signal or composite (Cs) signal
another Monitor.	output terminal
Note:	– Vertical sync (VD) signal output terminal
	Notes:
• Since the video output terminals on this Monitor are
loop-through terminals, the devices connected to this	• External sync signals are automatically detected when
video output terminal should be correctly terminated.	they come in.
Otherwise, pictures become abnormally bright or the	• When both horizontal (HD)/vertical (VD) sync and
Monitor screen gets affected abnormally.	composite (Cs) sync are connected, HD/VD sync signals
	will be used.
p VIDEO B terminals (page 12)

•AUDIO (L/MONO, R) input terminals (pin jack)

Connect these terminals to the audio output terminals of a VCR, etc.

•Y/C (S video) IN terminal (mini DIN 4pin)

Connect this terminal to the S-video output terminal of a VCR, etc.

•VIDEO IN terminal (pin jack)

Connect this terminal to the video output terminal of a VCR, etc.

Note:

•When both the video and S-video terminals are connected, the S-video terminal will have priority.

•Y, Pb, Pr (VIDEO) input terminals (BNC)

Connect these terminals to the component signal output terminals of NTSC or high-vision equipment.

Note:

•When these terminals are used as the component terminals (Y, Pb, Pr)—see “Setting the COMPONENT/ RGB B Input” on page 22, external sync signals (HD/Cs, VD) cannot be used.

7