Reset of Microprocessors

How to Operate the MDLP2, con’t

Wireless: Selects external sensor(s) only.

Wired: Selects the two internal sensors and any external sensor(s) connected to the MDLP2.

Note: When making a change to the cur- rent menu setting, the ENTER Push- button on the MDLP2 Control Panel must be used to effect the desired change.

Reset Lamp Life - The projection lamp used in the MDLP2 has a maximun life expectancy of 2,000 hours.

If at any time you would like to know how many hours of use are left for the lamp, press the INFO Push-button on the Remote Control and the On-Screen Display will appear indicating the num- ber of hours remaining. Refer to figure 35.

Information

Video Input	HDMI 1 - 1080p
Picture Mode	User 1
Gamma	A
Aspect	Normal
Lamp Mode	Economy
Iris	3
Lamp Life	921 Hours
Total Time	3653 Hours

Figure 35

When there is aproximately 100 hours of lamp life remaining, an On-Screen Warning Message will appear briefly. Refer to figure 36.

Warning

Lamp Life 100 Hours

Figure 36

If you have chosen not to replace the lamp at this time, a second warning message will appear with approximately 5 hours remaining. Refer to figure 37.

Warning

Lamp Life 5 Hours

Figure 37

Finally, the last warning message will appear On-Screen, the MDLP2 Projec- tor will shut Off and the Control Panel WARNING/LAMP LED will illumi- nate red. Refer to figure 38.

Warning

Lamp Life 0 Hours

Figure 38

After your McIntosh Dealer has re- placed the Projector Lamp, check to make sure the Lamp Life has been reset by pressing the INFO Push-button on the Remote Control. The On-Screen Display should indicate 2,000 hours. If it was not reset, please do so it at this time by selecting the Reset Lamp Life from the On-Screen Menu. Then select YES and press the ENTER Push-but- ton. Refer to figure 39.

Reset Lamp Life ?

Yes		No

Figure 39

Reset All - If it becomes necessary to reset all the menu settings back to factory defaults (except for the Lamp Life Setting), select the Reset All from the On-Screen Menu and then select YES and press the ENTER Push-button.

Refer to figure 40.

Reset All ?

Yes		No

Figure 40

In the unlikely event the controls of the MDLP2 stop functioning, the microprocessors can be reset by discon- necting the AC Power Cord from the MDLP2, waiting for 5 minutes and then reconnecting the AC Power Cord.