Texas Instruments manual Kit Operation, TSC2007EVM-PDK Block Diagram

www.ti.com

		Kit Operation
		Table 6. List of Jumpers
JUMPER	SHUNT POSITION	JUMPER DESCRIPTION
JMP1	2-3	Analog power select (default is +3.3VD)
JMP2	Closed	EEPROM address select. When installed and used with the USB-MODEVM, firmware for the
		motherboard is executed from the EEPROM on the TSC2007EVM. This is the default mode.

6Kit Operation

The following section provides information on using the TSC2007EVM-PDK, including setup, program installation, and program usage.

6.1TSC2007EVM-PDK Block Diagram

A block diagram of the TSC2007EVM-PDK is shown in Figure 1. The evaluation kit consists of two circuit boards connected together. The motherboard is designated as the USB-MODEVM interface board; the daughtercard is the TSC2007EVM described previously in this manual.

SLAU199 –March 2007 TSC2007EVM and TSC2007EVM-PDK User's Guide 5

Submit Documentation Feedback