Diamond CC1800 manual Appendix B, Daily Maintenance Task Chart

Appendix B

Daily Maintenance Task Chart

Table 6: Daily Maintenance Task Chart

	Date
								
	Lubricate blade shaft bearing
1.	grease fittings daily or two to
	three times daily when dry
	cutting.
	Inspect belts after first four
2.	hours of use, and then daily for
	tension and wear. Replace or
	re-tension as necessary.
3.	Inspect saw for damages.
4.	Tighten loose nuts and bolts.
	Verify that drive wheels fully
5.	engage rear wheels when
	transmission is engaged (self-
	propelled model).
	Clean air filter daily or two to
6.	three times daily when dry
	cutting (see engine manual).
7.	Check fuel level and fill as
	necessary.
	Check engine oil level and fill
8.	as necessary (see engine
	manual).
9.	Wipe down saw’s exterior.
10.	Wipe down engine’s/motor’s
	exterior and guards.
11.	Look for fluid leaks.
	Re-tension rear drive chain as
12.	necessary (self-propelled
	model).

Refer to engine/motor manual for daily engine/motor maintenance tasks.

30