Texas Instruments HPL-D SLLU064A manual FCC Warning

Page 6

Korea 080-551-2804

Malaysia 1-800-80-3973

Netherlands (English) +31 (0) 546 87 95 45

New Zealand 0800-446-934

Phillippines 1-800-765-7404

Singapore 800-886-1028

Spain +34 902 35 40 28

Sweden (English) +46 (0) 8587 555 22

Taiwan 0800-006800

Thailand 001-800-886-0010

United Kingdom +44 (0) 1604 66 33 99

FCC Warning

This equipment is intended for use in a laboratory test environment only. It generates, uses, and can radiate radio frequency energy and has not been tested for compliance with the limits of computing devices pursuant to subpart J of part 15 of FCC rules, which are designed to provide reasonable protection against radio frequency interference. Operation of this equipment in other environments may cause interference with radio communications, in which case the user at his expense will be required to take whatever measures may be required to correct this interference.

If your book does not discuss a product that creates radio frequency interference, delete this section from your preface. If your book does discuss a product that creates radio frequency interference, you must include this warning as it appears above.

iv

Image 6
Contents Users Guide Important Notice EVM Important Notice EVM Warnings and Restrictions Read This First About This ManualFCC Warning Contents FiguresTables Overview Sample Functional Configurations X4 Crosspoint Switch EVM Signal Paths X4 Crosspoint Switch Signal PathsSetup and Required Equipment Applying an InputSetup and Required Equipment Termination for Interfacing LVDS, CML, or Lvpecl Drivers Observing an Output Typical Test ResultsTypical Test Results Setup and Required Equipment EVM Construction Schematic X4 Crosspoint Switch EVM SchematicX4 Crosspoint Switch EVM Board Layout Board Layout PatternsLayer 1-Signal Plane GND Plane Layer 4-Vcc01 Plane Layer 6-GND/Signal Plane PCB Fabrication Requirements and Stack Up Bill of Materials Bill of Materials for SN65LVDS125A / SN65LVDS250 EVM