Starting the Standalone Demos
running. Otherwise you will see error messages raised when device drivers fail to open.
Once the EVM board has booted, the display should show a picture of the remote control. You use the IR remote to control the demos.
The order of the buttons on the actual remote may be different from the picture; if your remote looks different, find the buttons with the same labels on your remote.
To use the demos in standalone mode, follow these steps:
1)Check to make sure the batteries are installed in your IR remote.
2)The initial screen shows a diagram of the IR remote, which you use to run the standalone demos. Take a minute to look at the functions of the various buttons.
3)Since this is a universal remote, you may need to set it to use the codes necessary to run the DVEVM demos. To do this, hold down the "Code Search" button until the red light on the remote stays lit. Then press the "DVD" button and enter "0020" as the code (for older remotes shipped with the kit, the code is "020").
4)If you accidentally put the remote in TV or some other mode, press "DVD" to return the remote to the correct mode.
5)If the remote does not accept the DVD+0020 code, do a full reset by removing the batteries, pressing the Power button for at least a minute, then reinserting the batteries. Then program the remote as in Step 3.
Running the Demonstration Software |