Seiko Group 201 installation manual English

Page 11

2.Attach the base to the setting position on the IR Series, and secure it with the screws.

Note:

When attaching the base, note that the corners of the base are set as shown below.

3. Pass the cable for the DM-D500 through the base.

4. Insert the tab on the base into the hole on the support until you feel it click.

.

English

9

Image 11

Contents DM-D500 Trademarks Safety Precautions EMC and Safety Standards Applied About This Manual Contents Unpacking Usage Precautions when connecting to a TM printer Assembling steps AssemblingAttaching to the IR Series Required itemsEnglish Attaching to the TM-H5000II/TM-J8000 Assembling steps Page Attaching to the TM-U375/TM-U950 Attach the rubber feet to the printer English Attaching to the TM-H6000/TM-U675 Assembling steps Page English Paper roll cover Attaching to Other TM Printers Assembling steps using Velcro tapesWhen using support B for extension Assembling steps using screws Attaching to the DM-D stand Connectors for the DM-D stand Precautions on using the power supply unit Jumper settingWhen using the extension support DP-105 Computer Extension cable connector Extension cable for power supply Page Exterior Part Names and FunctionsTransmission speed DIP SwitchDIP Switch Functions DIP switchDSW2 No Function Setting the DIP switches Turning and Tilting the DM-D5 0 Performing Self test Self TestCheck Items of Self test General Specifications SpecificationPage Environmental Specifications Electrical SpecificationsReliability Specification Character Specifications