Seiko Group 201 installation manual DSW2 No Function

DIP switch 2

DSW2 No.	Function	ON	OFF	Default setting
2-1	Y-connection (*1)	Enable	Disable	OFF
2-2	Self test selection (*2)	Perform self test	Do not perform	OFF
2-3	20 column and 2 line	20 column and	256 ¥ 64 dots	OFF
	mode selection (*3)	2 line mode	mode
2-4	Device selection	Printer is	Display is	OFF
	default setting	selected	selected
2-5	Address 0	The display device number		OFF
		(1-7) corresponds to Address num-
2-6	Address 1			OFF
		ber 0 to 2.
		(All OFF are regarded as no dis-
2-7	Address 2			OFF
		play number.)
2-8	Reserved (*5)	-	Fixed to OFF	OFF

(*1)The “Y-connection enable” is set when a TM printer with no modular jack for the DM-D is connected with this product, using one COM port to connect both TM printer and DM display. In this case, an optional DM-D stand (DP-501) and a connecting cable are required. In the cases other than above, choose “Y-connection disable” (default setting).

(*2)This function can select whether or not you perform self test when turning on the power. See “Self Test” for details.

(*3)When selecting “20 column and 2 line mode,” this product can be used like the DM-D105/106/205/206. In this case, the graphic display and the original functions for the DM-D500 cannot be used, but when selecting “256 ⋅ 64 dots mode,” they can be used.

(*4)When setting to “Printer is selected,” data is sent to the TM printer, but is not displayed on the display. When setting to “Display is selected,” data is displayed on the display but is not output from the TM printer.

The selection can be changed using <ESC=> command.

(*5)Stay at OFF setting.

English

Note:

❏The changes in the DIP switch setting are effective when the power is turned on again.

❏The data transmission setting, such as data length, transmission speed, must be the same on both your computer and printer.

33