Seiko Group 201 installation manual Safety Precautions

Page 3

Safety Precautions

This document presents important information intended to ensure safe and effective use of this product. Please read this document carefully, and store it in an accessible location near your installation.

Precaution Headings

This document uses the two headings shown below to call attention to potential hazards. Failure to observe the information provided under or alongside these headings may lead to injury or property damage. Be sure that you understand the meaning of each heading before you proceed.

WARNING:

Indicates a potentially lethal hazard. Failure to observe a WARNING may result in severe injury or death.

CAUTION:

Failure to observe a CAUTION may result in personal injury, or in damage to equipment or other property.

Safety Precautions

WARNING:

Shut down your equipment immediately if it produces smoke, a strange odor, or unusual noise. Continued use may lead to fire or electric shock. Immediately turn the power off and contact your dealer or a SEIKO EPSON service center for advice.

Never attempt to repair this product yourself. Improper repair work can be dangerous. Tampering with this product may result in injury, fire, or electric shock.

Be sure to use the specified power source. Connection to an improper power source may cause fire or shock.

Do not allow foreign matter to fall into the equipment. Penetration of foreign objects may lead to fire or shock.

If water or other liquid spills into this equipment, immediately turn the power off and contact your dealer or a SEIKO EPSON service center for advice. Continued usage may lead to fire or shock.

English

1

Image 3
Contents DM-D500 Trademarks Safety Precautions EMC and Safety Standards Applied About This Manual Contents Unpacking Usage Precautions when connecting to a TM printer Assembling steps AssemblingAttaching to the IR Series Required itemsEnglish Attaching to the TM-H5000II/TM-J8000 Assembling steps Page Attaching to the TM-U375/TM-U950 Attach the rubber feet to the printer English Attaching to the TM-H6000/TM-U675 Assembling steps Page English Paper roll cover Attaching to Other TM Printers Assembling steps using Velcro tapesWhen using support B for extension Assembling steps using screws Attaching to the DM-D stand Connectors for the DM-D stand Precautions on using the power supply unit Jumper settingWhen using the extension support DP-105 Computer Extension cable connector Extension cable for power supply Page Exterior Part Names and FunctionsTransmission speed DIP SwitchDIP Switch Functions DIP switchDSW2 No Function Setting the DIP switches Turning and Tilting the DM-D5 0 Self Test Check Items of Self testPerforming Self test General Specifications SpecificationPage Environmental Specifications Electrical SpecificationsReliability Specification Character Specifications