Sharp PN-TPC2W7A, PNTPC2W7A manual Rear Connector Layout con’t

Page 10

Installation

Rear Connector Layout (con’t)

1.Power Connection (refer to the Rear Connector Layout on pg. 8) Use only the AC power adapter supplied with the system. Input: 100~240V AC 1.3A

Output: 12V DC 7A

Plug the 12V AC/DC adapter (as in the figure 1 above) to the PN- TPC2W7A’s power input jack (as in the figure 2).

2.Power Button

This button will stay lit if the PN-TPC2W7A is powered on. If the PN-TPC2W7A doesn’t power up after the AC is connected, then press this button to power up. If normal Windows shutdown is not shutting down the PN-TPC2W7A, then press this button for more than 4 seconds will turn off the PN-TPC2W7A. In this case, run Disk Cleanup in Windows next time the PN-TPC2W7A is powered up.

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents PN-TPC2W7A VersionGetting Started Introduction to PN-TPC2W7AFederal Communications Commission FCC Statement Specifications Specifications con’t Mounting PN-TPC2W7A on Sharp PN-L Series Displays Attach the mounting plateSet the AC power adapter in place Install the PN-TPC2W7AInstallation Rear Connector Layout Audio Port ChannelRear Connector Layout con’t How to Recover to Factory Installed Condition Before beginningSupport & RMA Trademarks
Top Page Image Contents