TO THE ADMINISTRATOR OF THE MACHINE
(Separate this page from the manual and keep it in a safe place.)
Factory default passwords
When accessing the system settings, the administrator password is required to log in with administrator rights. The system settings can be configured in the Web pages as well as on the operation panel. To access the system settings using the Web pages, a password is also required.
Factory default administrator password
Factory default setting: admin
Store a new administrator password as soon as the machine is installed.
Once the administrator password has been changed, the new password is required to restore the factory default password. Take care to remember the new password.
Factory default passwords (Web pages)
There are two factory default accounts: "Administrator" and "User". A person who logs in as an "Administrator" can configure all settings in the Web pages. In addition, an administrator can restrict access to other settings by enabling "User" accounts.
The factory default passwords are shown below.
| Factory default account | Factory default password |
|
|
|
User | users | users |
|
|
|
Administrator | admin | admin |
|
|
|
Forwarding all transmitted and received data to the administrator (document administration function)
✂
This function is used to forward all data transmitted and received by the machine to a specified destination (Scan to
Note:
•The format, exposure, and resolution settings of transmitted and received data remain in effect when the data is forwarded.
•When forwarding is enabled for data sent in fax mode,
•The [Direct TX] key does not appear in the touch panel.
•Quick online transmission and dialling using the speaker cannot be used.
For the users of the fax function
Important safety instructions
•If any of your telephone equipment is not operating properly, you should immediately remove it from your telephone line, as it may cause harm to the telephone network.
•The AC power outlet shall be installed near the equipment and shall be easily accessible.
•Never install telephone wiring during a lightning storm.
•Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
•Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
•Use caution when installing or modifying telephone lines.
•Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
•Do not use a telephone to report a gas leak in the vicinity of the leak.
•Do not install or use the machine near water, or when you are wet. Take care not to spill any liquids on the machine.
20