CAUTIONS
CAUTION
Do not install the machine in a location with poor ventilation. Install so that exhaust from the machine does not directly contact people.
A small amount of ozone is produced within the printer during operation. The
emission level is insufficient to cause any health hazard.
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m3) calculated as an 8 hr.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated area.
Do not install the machine on an unstable or slanted surface. Install the machine on a surface that can withstand the weight of the machine. Risk of injury due to the machine falling or
toppling. If peripheral devices are to be installed, do not install on an uneven floor, slanted surface, or otherwise unstable surface. Danger of slippage, falling, and toppling. Install the product on a flat, stable surface that can withstand the weight of the product. (Weight when various peripheral devices are installed: approx. 130 kg (287 lbs.))
When removing the power plug from the outlet, do not pull on the cord.
Pulling on the cord may cause damage such as wire exposure and breakage, and may result in fire or electrical shock.
Do not look directly at the light source.
Doing so may damage your eyes.
Do not block the ventilation ports on the machine. Do not install the machine in a location that will block the ventilation ports. Blocking the ventilation ports will cause heat to build up in the machine, creating a risk of fire.
Do not throw toner, a toner container (toner cartridge), or a waste toner box into a fire. Toner may fly and cause burns.
Do not install in a location with moisture or dust.
Risk of fire and electrical shock.
Store toner, toner containers (toner cartridges), and waste toner boxes out of the reach of children.
When the machine is installed, the adjusters
(4)must be lowered to the floor to secure the machine (prevent it from moving).
Rotate the adjusters in the locking direction until they are in firm contact with the floor.
If you find it necessary to
reposition the machine due to |
|
|
rearrangement of your office |
|
|
layout or other reason, retract |
|
|
the adjusters from the floor, |
|
|
turn off the power, and then |
|
|
move the machine. |
| Adjuster |
(After moving the machine, |
|
|
lower the adjusters again to | Lock | Release |
secure the machine.) |
The fusing unit is hot. When removing a misfeed, do not touch the fusing unit. Take care not to burn yourself.
Fusing unit
When loading paper, removing a misfeed, performing maintenance, closing the front and side covers, and inserting and removing trays, take care that your fingers are not pinched.
If you will not use the machine for a long time, be sure to remove the power plug from the outlet for safety.
When moving the machine, switch off the main power and remove the power plug from the outlet before moving.
The cord may be damaged, creating a risk of fire or electrical shock.
The machine includes the document filing function, which stores document image data on the machine's hard drive. Stored documents can be called up and printed or transmitted as needed. If a hard drive failure occurs, it will no longer be possible to call up the stored document data. To prevent the loss of important documents in the unlikely event of a hard drive failure, keep the originals of important documents or store the original data elsewhere.
With the exception of instances provided for by law, Sharp Corporation bears no responsibility for any damages or loss due to the loss of stored document data.
4