Sharp XR-32S-L, XR-32X-L quick start Info, Appendix

Maintenance indicator			Problem		Cause		Possible Solution
	Normal	Abnormal
Tempera-	Off	Red on	The internal	•	Blocked air intake	• Relocate the projector to
ture		(Standby)	temperature is				an area with proper
warning			abnormally				ventilation. (See page 8.)
indicator			high.
				•	Cooling fan	•	Take the projector to your
					breakdown		nearest Sharp Authorized
				•	Internal circuit		Projector Dealer or Service
					failure		Center (see page 65) for
				•	Clogged air intake		repair.
Lamp	Green on	Red on	The lamp does	•	The lamp is shut	• Disconnect the power cord
indicator	(Green		not illuminate.		down abnormally.		from the AC outlet, and
	blinks						then connect it again.
	when the
			Time to change	•	Remaining lamp life	• Carefully replace the lamp.
	lamp is
			the lamp.		becomes 5% or		(See page 52.)
	warming
					less.	•	Take the projector to your
	up or
							nearest Sharp Authorized
		Red on	The lamp does	•	Burnt-out lamp
	turning
							Projector Dealer or Service
		(Standby)	not illuminate.	•	Lamp circuit failure
	off.)
							Center (see page 65) for
							repair.
						• Please exercise care when
							replacing the lamp.
						•	Securely install the cover.
Power	Green on/	Red	The power	•	The lamp unit cover	• If the power indicator blinks
indicator	Red on	blinks	indicator blinks		is open.		in red even when the lamp
	Green		in red when the				unit cover are securely
			projector is on.				installed, contact your
	blinks
							nearest Sharp Authorized
	(Cooling)
							Projector Dealer or Service
							Center (see page 65) for
							advice.

Info

•If the temperature warning indicator illuminates, and the projector enters standby mode, follow the possible solutions above and then wait until the projector has cooled down completely before plug- ging in the power cord and turning the power back on. (At least 10 minutes.)

•If the power is turned off for a brief moment due to power outage or some other cause while using the projector, and the power supply recovers immediately after that, the lamp indicator will illumi- nate in red and the lamp may not be lit. In this case, unplug the power cord from the AC outlet, replace the power cord in the AC outlet and then turn the power on again.

•The cooling fan keeps the internal temperature of the projector constant and this function is con- trolled automatically. The sound of the cooling fan may change during operation because the fan speed may change and this is not a malfunction.

Appendix

51