Picture Quality Adjustments, Runco CL-610

On-Screen Display Menus

Picture Quality Adjustments

Runco CL-610

>Video S-Video Component1 Component2

RGB-HD

HDMI

------------------------

Aspect Ratio

Installation Option Setup

ISF Calibration

Adjustment

Brightness

Contrast

Color

Tint

Sharpness

Filter

Color Temperature

ICC Selection

Store Image Settings

Restore Image Settings

Brightness ➤

Contrast ➤

Color ➤

Tint ➤

Sharpness ➤

To access the picture quality adjustments, press Menu, highlight the active source and press Enter or ►. The picture quality sub-menu then appears (see above).

To adjust a setting, highlight it with the ▲ or ▼ button and press Enter to activate a scroll bar for that setting. Use the ◄ or ► keys to change the setting. When finished, press Exit.

Select Brightness to adjust the black level of the projected image (0 = minimum; 60 = maximum).

Select Contrast to adjust the white level of the projected image (0 = minimum; 32 = maximum).

Select Color to adjust the color level (saturation) of the projected image (0 = minimum; 64 = maximum).

Select Tint to adjust the hue of the projected image (0 = minimum; 30 = maximum).

Select Sharpness to adjust the sharpness of the projected image (-14 = minimum; +20 = maximum). This setting has no effect if the Sharpness Filter is set to 0 (refer to the next paragraph).

Filter ➤ The Filter setting controls the behavior of the Sharpness control. The available settings depend on the vertical resolution of the input signal, as follows:

•With a 480i signal, you can apply the sharpness control to either the input signal (1), the output signal (2), both (3) or neither (0).

•With a 480p or higher-resolution signal, the sharpness control is applied only to the output signal and only when you set the Sharpness filter to “on” (1).

32	Runco CL-610 Owner’s Operating Manual