Runco Reflection instruction

On-Screen Display Menus

NOTES:

1.To adjust the image position with a 480p or higher- resolution source, use the PC & HD Adjust controls in the Option menu, described on page 38.

2.The values shown represent where the approximate center of the image lies in relation to the total number of pixels available horizontally or vertically. This varies widely according to the signal; watch the image while adjusting.

Horizontal

Vertical

-	+	0

Video Black Level

>0 IRE

7.5 IRE

The Amplitude Adjust menu allows you to fine-tune the image	➤ Amplitude Adjust
aspect ratio by stretching it horizontally or vertically, in small
increments. The Horizontal control adjusts the image width
while keeping the height constant. Similarly, the Vertical
control adjusts the image height while keeping the width
constant.
This control compensates for incoming elevated black levels	➤ Video Black Level
present in certain video signals, and ensures that blacks in
the display are neither “crushed” (where dark grays appear
black) nor excessively elevated (where blacks appear dark
gray). By default, the projector automatically determines the
best setting according to the type of incoming video signal:
• 0 IRE – Used for DVD output with “enhanced black,”
SECAM, most PAL standards and Japanese NTSC.
• 7.5 IRE – Used for most NTSC video signals.
For some types of video, you may want to override the setting.
Generally, if black appears crushed when brightness = 30,
choose “0 IRE”. If black appears excessively elevated, use
“7.5 IRE.”

Lamp Power 250 W

Select Lamp Power from the Set Up Menu to adjust the lamp output level. You can choose to run the lamp as bright as possible (250W; this is the default setting) or you can choose the lower (200W) setting. Generally, lower lamp output can prolong the life of the lamp, but decreases brightness.

➤

Lamp Power

Primary +20

Secondary +20

The Remote Control menu shows you the primary and secondary infrared (IR) codes assigned to the CL-610. The Primary IR code is permanently set to +20. The secondary IR code is also +20.

You can change the secondary IR code if either:

•Another device in the theater (a DVD player, for example) is responding to commands from the CL-610 remote control in ways that are unpredictable or undesirable.

•You have multiple CL-610 projectors and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to

➤

Remote Control

Runco CL-610 Owner’s Operating Manual

The Amplitude Adjust menu allows you to fine-tune the image