Reset Lamp Timer ➤
Fan Control ➤
Return to User OSD ➤
use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific projector.
When you change the secondary IR code, the remote sends that code instead of the primary IR code.
NOTE: The Remote Control menu is
To simultaneously change the secondary IR code and synchronize that remote with a projector, point the remote at the projector, then press and hold ◄ and ► simultaneously for five seconds. The Remote Control edit window, shown at right, appears. Type a new,
The procedure for changing the secondary IR code on the remote only is the same, except that you point the remote away from the projector.
When you replace the projector lamp, you should also reset the lamp timer. To do this, select Reset Lamp Timer from the Set Up menu. Press the
NOTE: Reset the Lamp Timer ONLY after you replace the lamp. Otherwise, the reported “Lamp Hours” will be inaccurate.
WARNING! Do not exceed the recommended lamp life of 2000 hours. An old lamp becomes increasingly fragile and prone to sudden failure.
Select Fan Control from the Set Up Menu to control the operation of the projector’s cooling fan.
Mode: In most cases, the default Fan Control Mode (Auto Normal) will maintain the correct operating temperature. If the lamp frequently turns off due to overheating, or in certain
Fan Speed: If you set the Fan Mode to Manual, select Fan Speed and use the
After changing either of these settings, press Exit to return to the previous menu.
To exit the Set Up menu, use the up- or
To return to the Set Up menu, select it from the Main Menu, press Enter twice, then press MENU on the remote control. (You do not need to
Remote Control
Secondary +20
Reset Lamp Timer Reset only if you replace lamp
Are you sure?
No Yes
Fan Control Mode
Fan Speed
Fan Control
>Auto Normal Auto Hi. Altitude Manual
Fan Speed |
|
+2 - | + |
42 | Runco |