Connecting the Projector to Other Devices
Connecting the Projector to a Computer
Connecting to a Computer Using the RGB Cable
1 Connect the projector to the computer using the supplied RGB cable.
•Secure the connectors by tightening the thumbscrews.
2 To input audio signal, connect the projector to the computer using the supplied computer audio cable.
Note
•See page 93 “Computer Compatibility Chart” for a list of computer signals com- patible with the projector. Use with com- puter signals other than those listed may cause some of the functions not to work.
•When connecting the projector to a com- puter in this way, select “RGB” for “Signal Type” in the “Picture” menu. See page 46.
•A Macintosh adaptor may be required for use with some Macintosh computers. Con- tact your nearest Sharp Authorized Projector Dealer or Service Center.
•Depending on the computer you are us- ing, an image may not be projected un- less the signal output setting of the com- puter is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings.
RGB cable
Supplied accessories
Computer audio cable
Notebook computer
To RGB output terminal
To audio output terminal
1RGB cable
2Computer audio cable
Connecting the thumbscrew cables
■ Connect the thumbscrew cable making sure that it fits correctly into the terminal. Then, firmly se- cure the connectors by tightening the screws on both sides of the plug.
■ Do not remove the ferrite core attached to the RGB cable.
Ferrite core 
-18