Sim2 Multimedia ProC3 Switching the Projector on and OFF, With the keypad press Standby button

PROC3

6 SWITCHING THE PROJECTOR ON AND OFF

WARNING: Connect the projector to a power supply with a

nominal voltage within the following values: 100-240 V AC, 50/60 Hz. It must be earthed (Fig. 10).

Switch on from standby

With the remote control: press one of the keys 1...9 or with 0.

HV
PHICS	S-
	VIDEO
	RGB	4

2

	S-
	VIDEO
	1
REMOTE	AUDIO	OUT

Power Switch:

Position I: On

Position 0: Off

Fused

Power Socket

MENU
HDMI1	5

ESC

INPUT

0

I

With the keypad: press STANDBY button.

2)		HV
3
	G				S
	R				-V
		AP				IDEO
			HI				2
				CS	RGB	4		S-
								V
									IDEO
									1
							RE
							MO		AUD
							TE
									IOO
									UT

ME
	NU
H
DMI1	5

H	ESC
DMI2	6

Power Plug

Fig. 12

Fig. 10

In position I the projector will initialise itself (red and green leds on) and then goes into standby mode (red led on) (Fig. 11).

ME
	N
	U
H
DMI
1	5

0 I

When the unit is switched on from standby the lamp switches on; after a brief period of warming up, the image displays (blue led on). The projected image comes from the input selected when the unit was last switched off (Fig. 12).

If a very short time has passed since the unit was last switched off, the lamp may not switch on beause it is too hot.

Just wait a few minutes for the lamp to cool down sufficiently.

Fig. 11

12