•Read this manual carefully and keep it in a safe place for future consultation.
This manual contains important information on how to install and use this equipment correctly. Before using the equipment, read the safety prescriptions and instructions carefully. Keep the manual for future consultation.
•Do not touch internal parts of the units
Inside the cabinet there are electrical parts carrying dangerously high voltages and parts operating at high temperature. Never open the cabinet. Entrust all servicing and repair work to an authorised Service Centre. Opening the cabinet voids the warranty.
•Disconnecting the appliance from the power supply. The device which disconnects the unit from the mains is the power plug. Ensure that the power cable plugs and the electrical mains socket outlets are easily accessible during installation operations. Pull the plug, not the cable, to disconnect the unit from the mains.
•Use only the specified power supply.
Connect the units to a mains electrical supply with rated voltage of between
•Connection of the units to the mains power supply. Connect the unit as shown in Fig. 1.
D |
|
MI1 | 5 |
|
| E |
|
H | SC |
|
DMI |
| SOUR |
2 | 6 | |
| CE |
0 I
50/60 Hz
Fig.1
•Changing the fuses.
Before changing the fuse disconnect the unit from the mains power supply.
The fuse compartment is next to the power supply con- nector (Fig. 2). Remove the fuse holder (2) with a flat head screwdriver and replace the fuse (3). Fit a new spare fuse
(4). Use only T 5A H fuses.
PROC3
2 | 6 | OUR |
| CE | |
4 |
| 0 |
| I |
250 V
T 5A H
3 |
|
2 | 1 |
|
Fig.2
•Be careful with cables.
Make certain cables are routed so that people will not be impeded or tripped up.
Keep all cables away from children.
Install the unit as close to the wall socket as possible. Avoid stepping on power cables, make certain they do not be- come tangled, and never jerk or tug them; do not expose them to sources of heat, and make sure they do are not knotted or crimped. If the power cables become dama- ged, stop using the system and request the assistance of an authorised technician.
•Disconnect the unit from the mains power supply in the event of electrical storms and when not in use.
To prevent damage from lightning strikes in the vicinity, disconnect the unit during storms or when the sytsem is going to be left unused for a long time.
•Avoid contact with liquids and exposure to damp.
Do not use the unit near to water (sinks, tubs, etc.); do not place objects containing liquids on or near to the unit and do not expose it to rain, humidity, drops of water or sprays; do not use water or liquid detergent to clean it.
•Do not allow the unit to overheat.
To prevent this, allow a free space of at least 40 cm around the back of the projector.
Do not block the ventilation slots.
Do not place the unit near to heat sources such as ovens, radiators or other devices (including amplifiers).
Do not place the unit in a restricted area (shelving units, bookshelves, etc.) and in general avoid placing it in poorly ventilated areas as this can lead to overheating.