Installation

On-Screen Display Menus

Vision Model 50

Picture Adjust

Image Option

Projector Status

Installation

Service

ISF Calibration

Installation

Language

Picture Configuration

Keystone

OSD Position

OSD Timer

PIP/PBP Setup

Background Color

Language

Picture Conﬁguration

To access the Installation menu, press MENU, then press the ▲ or ▼ arrows to highlight Installation and press ENTER. The Installation sub-menu will then appear (see above). Press EXIT to return to the previous menu or press MENU to close all menus.

NOTE: When you change a setting in the Installation menu, the change takes eﬀect immediately; you do not need to press ENTER afterwards. (Press EXIT to return to the previous menu or MENU to exit.)

Press the ▲ or ▼ arrows to select from the available Languages: English, French, Spanish, German and Italian.

Press the ▲ or ▼ arrows to select the projector’s Picture Configuration. The projector can be installed on a ceiling or in a rear-screen configuration with one or more mirrors. There are four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling Rear.

Keystone To correct distortion resulting from the angle of the projection, select Keystone and use the ◄ or ► arrows to make the image rectangular.

NOTE: Vidikron recommends that the keystone feature not be used unless absolutely necessary, as it may cause artifacts in the image.

OSD Position Press the ◄ or ► arrows to adjust the horizontal and vertical position of the OSD.

OSD Timer Press the ◄ or ► arrows to set the OSD Timer. This timer controls how long the menus remain on-screen after selecting them. Select from 0 to 60 seconds, in 3-second increments. When you set the OSD to 0, the menus remain on-screen until you hide them by pressing MENU.

40	Vidikron Vision Model 50 Owner’s Operating Manual