Service

On-Screen Display Menus

To use the Picture-in-Picture or Picture-by-Picture features, press the ▲ or ▼ arrow buttons to select PIP/PBP Setup, then press ENTER.

Select PIP/PBP Enable from the PIP/PBP Setup menu. Press ▲ or ▼ to select Off or On, then press EXIT.

PIP/PBP Setup

PIP/PBP Enable

PIP Setup

PBP Setup

Press the ▲ or ▼ arrows to select PIP Setup, then press ENTER.

Press the ▲ or ▼ arrows to select PIP Off, Graphic in Video or Video in Graphic, then press ENTER.

Press the ▲ or ▼ arrows to select PBP Setup, then press ENTER.

Press the ▲ or ▼ arrows to select PBP Off, Graphic by Video or Video by Graphic, then press ENTER. Press EXIT to return to the Installation menu.

Press the ▲ or ▼ arrows to select the image Background Color (grey, blue or white). The Background Color appears when no incoming signal is present.



PIP / PBP Setup

PIP/PBP Enable

PIP Setup

PBP Setup

Background Color

Vision Model 50

Picture Adjust

Image Option

Projector Status

Installation

Service

ISF Calibration

White Balance

Gamma Selection

ICC Adjust

Image Over Scan

Video Black Level

Aperture Control

Image Shift

Amplitude

Horizontal Masking

Fan Control

Lamp Reset Timer

RS-232 Baud Rate

Remote Control

Return to User OSD

Service

To access advanced picture quality adjustments and projector controls, use the up- or down-arrow buttons to highlight Service and press ENTER. Use the number buttons on the remote to enter the Service menu passcode when prompted and press ENTER again. Then, press MENU on the remote control.

NOTE: You only need to enter the Service menu passcode the ﬁrst time you select that menu after turning on the projector.

Vidikron Vision Model 50 Owner’s Operating Manual