English
1.2.I/O Back Panel and Connectors & Jumper Setting
1.2.1.I/O Back Panel
PS/2 Mouse |
| Parallel Port |
| LAN |
|
|
| Line In | |
|
|
|
| |
USB |
|
|
| Line Out |
|
|
|
| |
|
|
|
| MIC In |
PS/2 Keyboard | COM A | COM B | USB | |
|
|
| ||
PS/2 Keyboard / |
| Connects PS/2 standard keyboard and PS/2 standard | ||
PS/2 Mouse |
| mouse |
|
|
|
|
|
| |
Parallel port (LPT) |
| Connects to printer |
| |
|
|
| ||
COMA/COMB (Serial port) |
| Connects to | ||
|
|
| ||
LAN (RJ45 LAN Port) |
| Internet connection with speed of up to10/100Mbps | ||
USB |
| Prior to use, please make sure that your system as well | ||
(Universal Serial Bus Port) |
| as the connected attachments support the USB interface. | ||
|
| If driver installation is required, please consult the USB | ||
|
| section of the user manual. |
| |
|
|
| ||
Line In |
| Connects to optical devices, CD players and other audio | ||
|
| input devices |
|
|
|
|
| ||
LineOut |
| Connects to speakers or headphones | ||
|
|
|
| |
Mic In |
| Connects to microphone |
| |
|
|
|
|
|
1.2.2.Connectors & Jumper Setting
SW1 (System Jumper)
System clock can be adjusted to 100/133/166/200MHz. SW1 allows you to adjust the system clock.
ON | ON: 100MHz (supports FSB 200MHz CPU, default) | If you are using a FSB | |
| 266MHz/333MHz or 400MHz | ||
OFF |
| ||
ON | OFF: Auto (133/166/200MHz , supports FSB 266/333/ | CPU, please set the jumper to | |
OFF (133/166/200MHz). | |||
OFF | 400MHz CPU) | ||
|
FDD (Floppy Disk Drive Connector)
The FDD connector is able to connect a single floppy disk drive via a FDD cable. Usually one edge of the FDD cable is marked in red, please attach this marked edge to position 1 on the
connector. | 2 | 34 |
| 1 | 33 |
6