AMD N2PAP-LITE, N2PA-LITE user manual Power Management Setup, S1POS, Pci Pme

Onboard FDD Controller

Select Enabled if your system has a floppy disk controller (FDD) installed on the system board and you wish to use it. If you install add-on FDC or the system has no floppy drive, select Disabled in this field. The settings are: Enabled and Disabled.

Onboard Serial Port 1/Port 2

Select an address and corresponding interrupt for the first and the second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.

UART2 Mode

This item allows you to determine which Infrared (IR) function of the onboard I/O chip to be used.

Onboard Parallel Port

There is a built-in parallel port on the onboard Super I/O chipset providing Standard, ECP, and EPP features. It has the following option:

Disabled
(3BCH/IRQ7)/	Line Printer port 0
(278H/IRQ5)/	Line Printer port 2
(378H/IRQ7)	Line Printer port 1

Parallel Port Mode

SPP	: Standard Parallel Port
EPP	: Enhanced Parallel Port
ECP	: Extended Capability Port

SPP/EPP/ECP/ECP+EPP

To operate the onboard parallel port as Standard Parallel Port only, choose “SPP.” To operate the onboard parallel port in the EPP modes, choose “EPP.” By choosing “ECP”, the onboard parallel port will operate in ECP mode only. Choosing “ECP+EPP” will allow the onboard parallel port to support both the ECP and EPP modes simultaneously. The ECP mode requires the use of DMA channel. So, after selecting ECP mode, the message: “ECP Mode Use DMA” will be displayed at this time. The user can choose among DMA channels 3 to 1. The onboard parallel port is EPP compliant. So, after you choose the onboard parallel port with the EPP function, the message: “EPP Mode Select” will be displayed on the screen. At this time either EPP 1.7 spec. or EPP 1.9 spec. can be chosen.

3-8 Power Management Setup

The Power Management Setup allows you to configure the system to most effective energy saving status in a manner consistent with your own style of computer use.

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software

Power Management Setup

ACPI Function			Enabled	Item Help
ACPI Suspend Type		S1(POS)
Video off Method		V/H SYNC+Blank
Power Button Function		Instant-Off		Menu Level >
Wake-Up on	PCI PME	Disabled
Wake-Up on	Ring/LAN	Disabled
USB Resume	from S3/S4	Disabled
Wake Up on	RTC Alarm	Disabled
X Time(dd:hh:mm) of Alarm		0: 0: 0

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Previous Values F6:Optimized Defaults F7:Standard Defaults

ACPI Function

28