Airlink101 ANAS550 user manual Installing 2-Bay NAS, Installing Hard Drives

Page 5

2. Installing 2-Bay NAS

2.1 Installing Hard Drive(s)

This section provides instructions on how to properly install a hard drive into the NAS device.

WARNING:

The 2-Bay NAS is not hot-swappable. Please make sure that it is turned off and not connected to the power outlet when performing the following assembly procedure.

Step 1 Make sure the front panel is unlocked.

Step 2 Slide the front panel up and then pull it off to access the drive bays.

Step 3 Insert a 3.5” SATA hard disk drive into the available drive bay until it is firmly connected to the SATA slot on the NAS. You can use the eject lever(s) to eject the installed hard disk(s). The front panel must be removed before ejecting the hard disk drive(s).

5

Image 5

Contents User’s Manual Table of Contents Introduction Package ContentsFeatures LED Indicators Installing Hard Drives Installing 2-Bay NASCongratulations! The hard drive installation is complete Configuring 2-Bay NAS Page Method B Using your web browser Internet Explorer or Firefox Page Method 1 Using the host name ANAS550 Accessing 2-Bay NASAll Programs Airlink101 Airlink101 2-Bay NAS Utility Page Page Setup Wizard Using Web ConfigurationPage Page Page Setup Device Setup LANPage Advanced User AdvancedAdvanced Group Advanced Quotas Advanced Network AccessPage Advanced FTP Server Advanced UPnP AV Server ITunes Server Select Enable or Disable for the function Dhcp Server Select Enable or Disable for the function Tools Time Tools AdminTools System Tools Firmware Tools Email Alerts Tools Power Management Tools RAID Device Info StatusSupport Downloading/Backing up Files Through 2-Bay NAS Scheduling Support StatusLED SpecificationsMailsupport@airlink101.com Technical Support